Philips Repair Tips

Search: philips
Results: 14243

Make	Model	Symptom	Problem	Solution	By
PHILIPS	FWM779	On and off or on and off	Transistor of the 7506 overvoltage detector with leakage on the regulator board		Stiltec
PHILIPS	21PT6456/78 L03.1L	No audio in rf, in av with audio	Rewrite eeprom, data lost		GDP2
PHILIPS	32PFL3404	Standby only	Replace c474 do 3v3		Eletrônica Mirage
PHILIPS	32PFL3404/78	Dead tv. doesn't connect at all. it doesn't even turn on standby	Defect on the power supply board. short because of lightning.	Burnt k6a65d (blown) I replaced it with the p7nk80 and replaced some burnt ceramic caps. in addition to the c807. TV working normally after that	Eletronica R Poraquê
PHILIPS	HTS3560X	Home does not turn on, nor does the stby light come on.	Main board short, and power supply board failure	Power supply board, capacitor c973 470μF 25v, defective and main board c950 smd ceramic capacitor shorted, its nomenclature can be found under the label.	RNSPTEC
PHILIPS	39PFL3508	Black screen with no image	Eliminate 3 tracks from the CN2 connector. This connector has 26 tracks, you have to isolate tracks 24, 25 and 26.	Eliminate tracks 24,25 and 26 from the socket that powers the display	MULTIMARCAS /ACARI
PHILIPS	21GX1618/78	With retrace lines	R3469 open. 3.9r		MARCONES DE ARARIPINA-PE
PHILIPS	FWM663X	Display does not light up.	D14 open power supply		Ogeid
PHILIPS	32PW8422 L05UAA	Image on component video with blurred colors and unstable HDMI or no image	Failure in the signal input of the HD video keyer on the Trident board	If the HDMI problem persists, replace the BA7657F switch ci	Wilson
PHILIPS	32PW8422 L05UAA	Image on component video with blurred colors and unstable HDMI or no image	Failure in the signal input of the HD video keyer on the Trident board	Remove the trident plate, remove the shields and replace the 6 capacitors (47μF 4v): 2273 to 2277. can be replaced with the 6.3v one as the dimensions are very close.	Wilson
PHILIPS	32PFL5604	Turns on and then turns off, the LED flashes 3 times, sometimes it works for 5 minutes.	C474 4.7uf 16v high esr on main board close to ci u8	Changing the capacitor, it could be a common electrolytic	GIBA
PHILIPS	29PT8457/78	Without stand by and voltages on the primary	Optoaclopador 7513	Replace optocoupler 7513 and cold solders	MMD128
PHILIPS	42PFL5332	Does not turn on, the blue light comes on, pressing the on and off button, the blue LED just blinks	Reverse right side, 02 cap 470uf x 35v swollen and reverse left side with 02 fdd8447l shorted	The cap 470μF 35v and fdd8447l components were replaced	Lima
PHILIPS	14GL1319	Tv works - reduced frame top and bottom-vertical	Trimpot centralizaÇao vertical-height-1o1-	Replace -trimpot- 1o1=100r	EMERSON RIBEIRO
PHILIPS	42PFL3403	Replace capacitor, intermittent defect.	C120 on power supply board with 10k/1kv pass	Replace capacitor, intermittent defect.	Eletronica EASI
PHILIPS	43PFG5100	No image, back light on	C202 on the display board. Pay attention because the first time I measured it did not present a short, however it had a low resistance.	Replaced it with another plate removed from a broken screen and it worked perfectly. It is very important to add another one and never leave it without a capacitor.	Mário Fernandes Testoni Junior
PHILIPS	42PFL3507	TV does not light up on standby. correct power supply voltages.	U702 - 3.3v (releasing only 2.5v).	Replace regulator u702 - 3.3v on the main board (an ams1117 - 3.3v was placed in its place, it worked perfectly).	Company Tronics
PHILIPS	32PFL3605	No image, with stripes, and making a noise on the main board	750k resistor on the bottom of the board next to the flat cable that goes to the screen		Rodrigo cofferi
PHILIPS	32PFL5604H Q543.3E	Does not start LED blinks 3x	C513 10nf1000v na power supply		LUIS ALBINO
PANELA A VAPOR PHILIPS	R19140/90/A	Does not turn on without power on the PCI board	Causes l1 open with a lot of glue on the contacts	Replace the l1 on the board and remove the glue, in my case I cleaned it with thinner	Francisco Medeiros/ Barbacena MG