☰

Philips Repair Tips




AIWA
BEKO
CCE
CINERAL
DAEWOO
FUNAI
GRADIENTE
GRUNDIG
HITACHI
ITT
JVC
LG
MITSUBISHI
PANASONIC
PHILCO
PHILIPS
PIONEER
RCA
SAMSUNG
SANYO
SHARP
SONY
THOMSON
TOSHIBA
VESTEL


Search: philips
Results: 14206
Make Model Symptom Problem Solution By
PHILIPS 32PFL3008/78
Screen turns blue and turns off I don't know I don't know Ismael
PHILIPS 40PFL7007T/12 FSP163-4FS01
Error code 3. dead Verificar/substituir f1(4a); q101, q102 (20n60c3); d102, d103 (bav70w); zd101 (9v1); r122, r130 (5r1); r124, r131 (30r); r125, r128 (10r); u101 (ssc9522s); Rui
PHILIPS 32PFL5403/78
Power supply turning on standby with 3.3v! but without 12v!! Ic901. dda001bg Replacement Rodrigo cofferi
PHILIPS 21PT5433/78R
LED lights up when pressing CR power goes off +b at around 120v and the TV does not oscillate Transistor 7422 open, change and move on to the next one. samuel leite
PHILIPS FWM377
Does not turn on only displays clock and standby Replace of q312 d882. Remembering that if the CD board and all the flats are not connected, the device will not work. Mitzko eletrônica
PHILIPS FWM663X/78
Nothing turns on, not even the LED Diode 15 in the secondary power supply close to capacitors 13 and 14 it was shorted MARCOR ELETRONICA
PHILIPS 42PFL4007
Totally inoperative Changing the hdmi switching ci Replace ci hdmi SAS ELETRÔNICA
PHILIPS 42PFL7007/78
LED on, it has 3.3v, not 12v, it has vcc 17v but it doesn't start. Transistor q603, (stk0160) mosfet similar to a bc547, was shorted asking for the switch. of the ic600. Floor under por 5n60 uo 6n,7n etc.. GDP2
PHILIPS 32PFL3404/78
Turns on, after a short while it makes a loud hissing noise from the speakers and turns off Defect in capacitors According to tips from colleagues, I replaced capacitors on the main board, c474, c110, c532, c534 and x4 oscillator crystal, first of all replace the c110 capacitor, then the other capacitors and lastly the oscillator crystal Claudio Eckert
PHILIPS 32PFG 5103
Does not turn on, nor does standby light up R9101 (0.27r) changed Luis fischoeder
PHILIPS 14PT3131/78R
Dark image but with some characters 3442 resistor near open flay-bak MARCOR ELETRONICA
PHILIPS 50PUG6700
50PUG 		Defect, nothing turned on, no 12 volt voltage, necessary to turn on the TV Snd diode below the power supply board, short, sk510c Replace sk510c diode is below the power supply board.smd, sk510c 150 v.5 amp. Eletrônica Moisés N.H
PHILIPS 221TE4L
Totally dead Cap´c922 470/10 is not and c911 does not exist Cap. 470/25 rn eletronica ce
PHILIPS 42PFL7412/78
Screen flashes and turns off, returning to standby bay, if you press power, it turns on again, but if you move it, it turns off again. U202 photo coupler, just change it. This power supply has 4 photo couplers. This defect is more common in the u202.
PHILIPS FWM462X/78
Does not leave stand bay Coil that feeds the CD drive 8 v supply in series with it before it has a 22 r resistor also check, in this case it can be seen that the mechanics do not work Replace the coil and check the carousel and tray belts! Please note, this device only works if the CD mechanics are perfect.
PHILIPS 40PUG6300/78
Doesn't start. primary power supply only Large smd diode on the 12 volt line. good luck to everyone! Eletrônica Cecé. Brumadinho MG
PHILIPS 29PT4635
Horizontal lines in the image at the top of the screen C2487 CARLOS ELETRONICA
PHILIPS 42PFL3604/78
LED on and not turning on / 3.3 volts oscillating C806
PHILIPS 14PT316A/78R
In a completely colorless channel, it only showed color in the osd. Ci micro 7600 and eprom memory. (be careful, only turn on the TV after having replaced both, as if you only turn it on with the memory changed, the computer corrupts it again and the defect continues) Replace the computer, and replace or burn the eprom. (tec. edfersom varjota-ce) Edfersom
PHILIPS 40PFL6606 40PFL5606
Q552.2L 		Tsound is no standby, u101 does not oscillate, no 3v3. Zd103 (7v5) leaked and/or altered. Replace zd103 Mau3000