Philips Repair Tips
Search: philips
Results: 14210
Results: 14210
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| PHILIPS |
29PT4635
|
Doesn't start | Horiz exit. shorted | Replace os trans. q7460 / q7461 / q7463 e c2455 | eletronicaapolo |
| PHILIPS |
29PT4643
|
Does not connect sh in short | When changing the sh, it heated up until it burned. | Replace o fly (jj0501-8604) | cabeção natal |
| PHILIPS |
14PT3336/78
|
Doesn't work | Resistor r3445 (open) | almirguarani | |
| PHILIPS |
20PT120
|
It doesn't turn on, when you plug it into the socket it gives a crackling sound (it's loud, everything is fine but there's no sound or image). | Check the ci tda 8360 look at the iron sheet that surrounds it | Resolder the plate that covers the ci tba8360 | deusomar |
| PHILIPS |
2IPT8467/78
|
No RF sound, AV sound only | Cap heletrolitico 10uf*50v - loc -2205 | Replace faulty component | JDANTEX |
| PHILIPS |
29GX1899
|
Stop | Coil pin deflection bad contact burning by448 diode and horizontal output | Resolder the deflection pin, replace the diode by 448, I didn't have it by 448, I put it by 228 and it works, replace the horizontal output transistor and run for a hug. | fernando timbauba .PE. |
| TV PHILIPS |
21PT9467C/78
|
Without image and normal characters. | D-302 aberto | Replace | wagner |
| PHILIPS |
29PT9467/78
SK5.0A |
Completely stopped | Shorted power supply regulator. | Replaced ci-w6556a-pos.601-supply regulator. | Clayton |
| PHILIPS |
29PT5645
|
Vertical retrace, folding image at the top of the screen. | C2465 = 10/100v in the vertical stage | Bruske | |
| PHILIPS |
FW670P
|
When you increase the volume it goes to total (maximum) | Replace eprom | Schulz | |
| PHILIPS |
29PT4635/78
|
After turning on, image oscillates between RGB and off | Trc / cinescopio | Replace of the same | eletronicaapolo |
| PHILIPS |
14GL1010
GR1-AL |
I'm a year old | R 621 cut | Replace | Elias2305 |
| PHILIPS |
14GX1618/78R
ANUBIS VA |
Jagged image | Cap 6531 47/ 160 volts, one of the terminals was corroded, as it is glued, you can't see it, you can only remove it from the board. | jorge mota | |
| PHILIPS |
21PT5435
L03.LAA |
Alloy keeps buzzing in socket with spark of fire white screen flashing cmo frorecent | It appears to be the socket or very high horn coming from the flayback. but the defect is the tube | Replace the bubo | |
| PHILIPS |
21PT8467/78
|
Normal audio and characters, no luminance | 100k resistor, position r3442, line abl | Replace the same | eletronicaapolo |
| PHILIPS |
29PT4643
|
Vertical keeps shrinking at the bottom and sometimes turns off | Chap. 2625 (smd 2.2uf x 6.3v) close to the Audio ci | Ronie Grein | |
| PHILIPS |
14GL1015
|
Low power supply less than 40v | Flyback shorted between pins 9 and 10 | ELETRÔNICA GOMES | |
| PHILIPS |
14GL1015
|
When you tune in, it's black and white or changing the channel has interference | Broken channel processor | ELETRÔNICA GOMES | |
| PHILIPS |
14GLK1015
|
Dead, supply low less than 40 v, | Short flyback, pins 9 and 10 | ELETRÔNICA GOMES | |
| PHILIPS |
20GX1659
GR6-AL |
The TV has sound but no image, when you open the screen, it gives you a dark, speckled screen (the stand-by LED flashes four times) | Saida vertical tda8356 | Replace tda8356 | Eletronica Som & Imagem |