Philips Repair Tips
Search: philips
Results: 14210
Results: 14210
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| PHILIPS |
21PT9467C 78
SK 4.1 LCA |
It turned on and the channel character appeared and when it turned off it went to STBI | Defect abl c303 open replacement | Problem solved | eletronica poleza |
| PHILIPS |
29PT4635/78
|
Does not turn on but the stand-by LED blinks | C2455(47uf/25v) | AELSON | |
| PHILIPS |
25PT848A
|
No screen image with 0 volt | Shorted screen pin | In my case, I tapped the series lamp from the ground to the screen on the tube and the short came out | ANTONIO NOBREGA [PATOS.PB] |
| PHILIPS |
14PT1686/01B
L01.2E |
Lights up and goes out after a few seconds | Transistor 7313 on the kinescope board shorted | jose almeida tavares | |
| PHILIPS |
FWC270
|
No sound! When you remove the power cable from the socket, audio comes out in the boxes 8817 10/02/10 ] [60.00 | The defect was the MOSF 7302 =stp16ne06, I removed it and the sound started working normally again, I put one from the scrap IRFZ48N and it was great. | marcos melo . CASCAVEL CEARA | |
| PHILIPS |
21PT5435
|
No color | Replace epron 24c16wp | Nilton Neves | |
| PHILIPS |
32PW 8608-12
|
Just open the kinescope a little | I don't know, I wish you could give me a tip | luis cunha | |
| PHILIPS |
29PT 4635
L01-1C |
Burnt bu 4508 was replaced and didn't work | It was c2455 | luizsa | |
| PHILIPS |
FW C270
|
No sound at 220v put normal sound at 110v | Def. fe 7302 p16ne06 ou equiv. irf822 | Help yourself leave your tip | ELETRONICA ARNI>L. LEAL-SC |
| PHILIPS |
14PT 110A
|
Does not turn on pulsating power supply | C 2550 331n x 1k6 shorted Just change it and it was ok! | CARLOS AUGUSTO ELETROSILVA CANAVIEIRAS BAHIA | |
| PHILIPS |
21PT230A
|
Time calls time doesn't call | C 2442 smd with cold soldering, just resolder and go for the hug | CARLOS AUGUSTO ELETROSILVA CANAVIEIRAS BAHIA | |
| PHILIPS |
20PT3331/78R
|
Audio with strange whistling noise | When testing the audio circuit I found a 4n7 smd c2201 capacitor without capacitance | When replacing c2201 4n7 smd the TV worked with normal sound | Weslley Mendes |
| PHILIPS |
21PT5433
|
TV turns on, relay clicks as if it were going to work, but the filament doesn't light up and after a few seconds it turns off by itself. | Replace without testing the 2 resistors 3443 and 3444, both 3r3. problem solved. | ELETRONICA SÃO FRANCISCO
|
|
| PHILIPS |
20PT4331
|
When turning on without audio, as the TV heats up, audio appears. | 470uf 16v capacitor 2444 | This problem usually occurs when the capacitance is below 400μF | ELETROSONIC (GARANHUNS) |
| PHILIPS |
14PT3336
|
Green screen with retrace line | Pci cinescopio | Rebuild the PCI | eletronicaapolo |
| PHILIPS |
29PT5642
|
Doesn't start | Photo coupler | Ic7513 in most cases of philips without connecting, and with horz output, good 3v3, 1v8 regulator transistors, the defect is almost always in the photo. | ELETROSONIC (GARANHUNS) |
| PHILIPS |
29PT8457
|
Lack of width | Check -2.2 v at the base of the tr 7408 in case of positive voltage change c2486 | Capacitor c2486 with leaking hd line | ELETRO CENTER |
| PHILIPS |
14PT3131
|
No audio | Open speaker coil | Replace speaker | eletronicaapolo |
| PHILIPS |
29PT4636/78
|
Does not turn on, LED does not light up | Horizontal output, short between base and emitter. | Transistor replaced | |
| PHILIPS |
20PT4331
|
No audio | C 2444, note: location near. from the vertical outlet | Replace c2444 470mf/16v | carlos (dalua) |