Philips Repair Tips

Search: philips
Results: 14210

Make	Model	Symptom	Problem	Solution	By
PHILIPS	14PT1353 L6.1	TV turned on with vertical closed, wire that goes to the deflection coil burned, due to the flyback arc, magnetized tube, due to the degausig coil terminals being broken, image blurred in cold weather.	Solder new vertical deflection wires, solder degaussing coil terminals, replace flyback.		geek1966
PHILIPS	21PT3131 L03.1LAA	Vertical	Partially closed at the top	Check. if the voltage at the collector of the 7464 below 20v: replace c2460 vert +b booster doubler.	tonintvtec
MINI SYSTEM PHILIPS	FWC 270 ***	When the mini system arrived at home I realized that there was no sound at 110v, I changed the sound output and it still had no sound, when I put it at 220v the sound appeared, I was intrigued and thought about changing the transformer.	Fet transistor p16ne06, when the current flows it trips and causes mute so I released it and the sound appeared, you can't do without it, it's output protection and I put the IRF 822 replacement in and it was fine.	Replace the transistor p16ne06 with irf 822 and that's it.	wagner
PHILIPS	DVD-625/781	When inserting the disc into the device, the display shows load flashing at a high frequency, and the disc does not spin.	Replace the disc drive motor, it's ok.		CLÁUDIO RIBEIRO, TECNOSAT ELETRÔNICA, JATAÍ-GO.
PHILIPS	20PT9467	Dead	Ci power supply and photo coupler		ELETRONICA ROBSON
PHILIPS.	29PT4631/78R	Black band on one side of the screen, approximately 5 to 7 cm wide.	Position capacitor 2486 disc=27pf by 2kv with leakage.	It was just a matter of changing and going out for a hug, it was….ok.	Armando da Eletrônica só Tv.
PHILIPS	14PT418A	There's a plot, don't tune in.	R-3000, r3001 changed.
PHILIPS	FW M355/22	Without audio outputs on speakers, with audio on phones	Pa power supply (AN7830a pin 1) w/ 36v instead of 16.7	Mosfet transistor 7302 (which regulates the 16v7) in dc.	jose luis calcada
DVD PHILIPS	DVP3142	Engine doesn't turn, it's not the engine	Solution to change r76 on the mpg plate, very common in this model		fernando ferreira da silva
PHILIPS	14PT3131/78R PT3131	Green screen, with retrace and disarming	Resistor connected to transistor 7310 on the kinescope PCI (open/check)	Replace of the same	vinicius
PHILIPS	FW-M912	Does not turn on, tries to turn on, it seems that the relay does not arm or the relay keeps vibrating	Faulty relay t904		BRUSKE
PHILIPS	29PT4640/78	Vertical closed + or - 4 cm at the top and bottom with wavy lines from the middle to the top about 15 cm on the screen	I replaced the c2252 1n that goes on pin 17 of the computer and it worked		Sidney Alves
PHILIPS	29PT4635	Noise in the horizontal output stage sometimes turns off	C2455 47/25v	Capacitor replaced
PHILIPS	20PT122A/78R	Image with horizontal pole bending image	Transistor 7440 bc 847	Replace of the same	eletronica poleza
PHILIPS	25PT5322/16 MD1.2E AA	Does not stop tuning, and the tuned channels have sound but with a distorted image	Coil 5114 (50131)	Bobune is on plate 8211 015 0967 4	JOAQUIM CUNHA
PHILIPS	DVD3124	Don't read	Engine does not turn	1r resistor connected to pin 12 of the open driver	p
PHILIPS	20PT3331	TV with the top part of the vertical partially facade and with lines of retraces	The capacitor c2460, 83 or 83 nf, was replaced and the problem was resolved	As a precaution, also replace capacitors c2446, c2465, c2463,	heliomar
PHILIPS	20PT534	Oscillating weakly with reduced frame	I changed the eprom memory and the device worked normally again	Memoria eprom	asr
PHILIPS	14GL1313	There is no image, it just chirps very softly 22k resistor chasis (3501)	Change the res: from (22k)		eletronica ceara
PHILIPS	20GL1042T	There is sound and no image when powering the esklim the screen turns green with a defect retraction line and the ci tda3565 chas:(ic260)	Replace the same		eletronica ceara