Philips Repair Tips

Search: philips
Results: 14210

Make	Model	Symptom	Problem	Solution	By
PHILIPS	14PT314A/78R	With drizzle and no image on pin 8 of the varicap there is 32v replace the varicap	Change the varicap.		eletronica ceara
PHILIPS	20PT3331	Closed image on the top side about 3 fingers plus about 20 white lines below the black band downwards the normal image to solve the problem replace 2 capacitors chas: (2465) 10uf 160v or another chas: (2446) 470uf 16v ok? ??	Replace the 2 capacitors		eletronica ceara
PHILIPS	14PT110A L7L	It didn't turn on, it stayed on standby, when I pressed the channel button it flashed several times very quickly	There was a lack of 9v voltage coming from pin 5 of the fly, 1Ω resistor 3499 open and transistor 3480 bc337 shorted		Romolo
PHILIPS	20PT3331	No sound	Good friends, this TV had no sound, normal image, change the capacitor c444, ok?		MACIEL CEARA
PHILIPS	14PT218 L01.2L	Stopped, inoperative. totally dead.	Power supply. power supply regulator 7520 (tea1507) and photo coupler 7515 (tcet1103(g))	After changing the regulator, the power supply worked, however, it had 130v at the +b of the fly back and would not start. Noting that the photo coupler seemed to be fine but, after replacing it, the TV worked normally.	Tec Video
PHILIPS	14PT100G	Vertical closed	In this case it was the 3412 (22k) open resistor		fernandocamarques
PHILIPS	21PT4428/16B MD1.11E AB	Without image and sound, dark section and at the end of the lower limit a horizontal section	Fusivel 1463; d6463 (byv27-400)	We don't have +29v vertically	joaquim cunha
PHILIPS	21PT6456	Reduced height, image folded at the top	C2465. 10uf/160v.		nunes
PHILIPS	29PT8422	When the device is turned on, a narrow vertical strip appears and it immediately turns off.	Sun from burning on the deflector connection terminals (horizontal).	Resolder them.	CLÁUDIO RIBEIRO,TECNOSAT ELETRÔNICA,JATAÍ-GO
PHILIPS	20PT326A/78R	Stand by LED blinking and does not oscillate/secondary power supply oscillating	I changed the power supply capacitors c 2530 and c 2540
PHILIPS	29GX1899	TV turns on with dark screen has filament and sound.	Update or change eprom, good luck..		Clayton
PHILIPS	14PT3131 L03.1L	Green screen for seconds and turns off	Transistor 7310 (kinescope board)	Replace it even if it looks good, as it doesn't show up on the multimeter. I advise you to replace them all to avoid returns and guarantee the service.	Tec Video
PHILIPS	20PT3336/78	Dark screen with/characters, normal sound	R3442- 100k.		nunes
PHILIPS	29PT4635	Cushion effect (two bands left and right of the screen)	Something in the fet 7400 transistor circuit	In my case it was a 4.7r resistor open in position 3411	JUNIOR
PHILIPS	20PT228A/78R ***	When the TV arrived home, it turned on only the LED lit up and there were times when it turned on whenever it wanted after it worked, it could go on for a whole week, I checked the power supply, there was only 100v on the vbat.c-2409 it was dry l-5561 open.	C-2409 dry l-5561 open (change)	Do not use used for new.	wagner
PHILIPS	20PT4331	No audio, amplifier ok, speaker ok	Volume line deficiency		c@rlinhoselectro
PHILIPS	DVP3124	Drawer does not open or takes time to open and cannot read the disc.	Change the spindle motor that turns the disc.	If after installing the motor the disc still does not rotate, place a 1r resistor from pin 12 of the am5888s to the negative of the spindle motor. That done, problem solved.	ELETRONICA SÃO FRANCISCO This email address is being protected from spambots. You need JavaScript enabled to view it.
PHILIPS	29PT8457	It started showing a sentence on the screen, medium voltage, low and then went out, becoming completely inoperative	After changing the (tcet 1103g photo-coupler) it worked normally		c@rlinhoselectro
PHILIPS	29PT4631 LO1.1L	3 rgb lines at the top of the screen	Capacitors 2252 and 2253	Just remove it and test	SIMAS433
PHILIPS	21PT5433	Top of vertical partially closed	Replace the polyester capacitor c2460 =82k/100v or 82 nonoparaids for 100 volts, as a precaution also replace c2446,c2465,2444,2463.	But in this case the main defect was the c2460 with loss of capacitance causing the TV to produce this defect	This email address is being protected from spambots. You need JavaScript enabled to view it.