Search: philips
Results: 14210
Make Model Symptom Problem Solution By
PHILIPS 29PT6456
L04-UAA
Works for +or- 1 min, taps the image and turns it off Poor filtration at +b (160v) Replace the cap 2552 (with less than 93μF) MAIRES
PHILIPS 24PW6006/01
L01.1E
Power supply without output voltages Slightly low voltage on pin 1 of the ic7520 (power supply) C2526(470n smd)com fuga MeA
PHILIPS 20PT424
Does not turn on, the standby LED flashes Power supply cap 100uf/25v change it you can measure it is good I replaced it and the TV went blank ELETRONICA ARNI - L. LEAL
PHILIPS 20GL1049
Just getting uhf channels. Altered resistor3101(22k) Luciano Fontes
PHILIPS 29 PT 5645/78
TV didn't work primary power supply seemed to be fine but after the tr there was no b - primary power supply doesn't work After a lot of head-scratching, a 82k secondary 3575 resistor was opened ELETRÔNICA NYLSOM - This email address is being protected from spambots. You need JavaScript enabled to view it.
PHILIPS 20PT3336/78
Does not enter the av and there is no sound Memory exchange Obs. I replaced it 3 times and recorded it f'' Neguinho(itapevi)
PHILIPS 21GX1668/78R
Tv doesn't work Check r3511(24k) altered value You can replace it with a 22k one almicrrc
PHILIPS 14GX1610
Stop without +b Replace do flay back at 2079/b4 bt
PHILIPS 20PT424A/78R
L9.2A
Stand by flashing quickly Replace capacitor 2530 and 2540 somprimos eletronica
PHILIPS 14GL1310
Buzzing in the speaker without sound Capacitor 140 (ceramica 22k)
PHILIPS 29PT558A
Does not oscillate 3491 - 10k silva2
PHILIPS 29PT652
A8
When turning on there is a smell, it doesn't work, it stops Shorted capacitor 2634 Replace fernandoferreira
PHILIPS 21PT5143
TV oscillating, but completely turned off, found that there was no screen. removing the socket from the tube, the voltage arrived, resulting in a short between the pins: 8 (screem) 5 and 6. I removed the short using mains voltage (220v) with a resistor in series. The short was eliminated and the tube was ok. Léo, Natal-RN
PHILIPS 29PT4631
Does not tune channels and disarms in 15 seconds. 5v voltage originating from the tsh, with 2.8v Replace trans. 7482 : bd135 This email address is being protected from spambots. You need JavaScript enabled to view it.
PHILIPS 20GL1346
Green and pink and blurred image Incorrect transcoding Replace tda4662., first check the ceramic capacitors connected to the circuit ELETRÔNICA ESTUDIER
PHILIPS 25ST2451/12B
GR2.2AA
Dead power supply. no voltages in the secondary. You can only hear the primary wanting to start. Replace c2545(1nf5-2kv) next to the high transistor (7545) TELEGAIA
PHILIPS 14GL1014
No image with sound Replace c2410 100x25v Resistronic
PHILIPS 14PT3131
It did not accept commands from the remote control or the pinel even though the receiver was ok With the device turned on, short circuit at the input, and then I disconnected the power plug, then turned it on and it worked normally c@rlinhoselectro
PHILIPS 29PT4641
Dead 7531, tea 1620. silva2
PHILIPS 21PT9467C
SK4 0L
Textile factory Water in the varicose vein jamil