Philips Repair Tips

Search: philips
Results: 14210

Make	Model	Symptom	Problem	Solution	By
PHILIPS	20PT222A ANUBIS	Vertical closed at the bottom	Ic 7401 / c2463 / c2414 / c2443 / ic 7620	Replace the ci if it doesn't solve the problem, check the capacitors or eprom	This email address is being protected from spambots. You need JavaScript enabled to view it.
PHILIPS	21GX1666/789 ANUBIS	Blinking LED off	High power supply caused the device to block	Adjustment of the power supply through its module and connecting pins 1 and 20 of the ic7600 to unlock code ff, f8	rrsva
PHILIPS	29PT4635/78	When I turned on the TV it kept chirping constantly.	It's easy for the bu to burn out, I just changed it and it was stuck as a precaution, change the horizontal capacitors		This email address is being protected from spambots. You need JavaScript enabled to view it.
PHILIPS	29PT5642 /78 L04	Colored lines and does not open the vertical, then protects	Check d 6457 smd short		Master
PHILIPS	29PT5642	Vertical open open about 15cm with a sharp line right in the center and at the top and bottom of the opening it formed a sine wave with colored lines on both sides in red. green, blue.	Defective deflector detected on the bottom of the coil with I couldn't find it for sale, I opened it and I fixed the wire that was broken and the TV started working normally again.		Rivaldo Lira
PHILIPS	21PT6456	Screen closed without sound	Memory deconfigures	Configure or replace for another	EVALDO GOMES
PHILIPS	14PT418A/78R	Turning off and when held on and with green and yellow arrows in the image.	Kinescope	Changing the kinescope	ARISTEU
PHILIPS	20PT324A	Inoperative led off	Mp 08 / 116	Replacing it with the original serves as a fuse	EVALDO GOMES
PHILIPS	20GL1045	Vertical burned	Queima ic pos. 7410 (tda3653/bq)	Diode pos. 6565 (BYD33G) and POS1565 fuse (630mA)	jfmendes
PHILIPS	14PT3336	Intermittent on and off	Does not adjust the screen	R g b resistors replaced - I replaced them and solved the problem	OTECNICO.20M.COM
PHILIPS	29PT4640	It doesn't start horizontally, it only starts when you turn it off and when you turn it on at 110v	Pre-horizontal transistors, it is also ideal to check the 2 filter capacitors in this sector		Ronie Grein
PHILIPS	14PT3336/78	TV turns on with retraction lines turns off in seconds	Change all the transistors on the kinescope PCI, even though they appear to be good	Case solved	otecnico
PHILIPS	29PT5642	Noise in the tube and very blurry image	Fly back ruim	After changing the kinescope socket, there was no other solution, I replaced the fly and the TV worked normally.	marcelo quinelatto
PHILIPS	14PT110A	Turns on and off and changes channels on its own	Replace the 7650 transistor (smd bc848)		somprimos eletronica
PHILIPS	14PT212	Does not turn on or turn on standby	C 2447 shorted to horizontal output side		antonio nobrega(patos.pb)
PHILIPS	20PT324/78R ...	The screen brightens, but with lines, then turns off.	Lack of oscillation in the r.g.b output preamplifier transistors;..note: cold soldering.	All the pre and r.g.b output transistors were resoldered, and it was...beautiful.	Armando
PHILIPS	21PT 8467/78 S L O 3 1 L	TV doesn't work	When this TV turned on, it made a hissing sound like a high leak and a line appeared in the vertical direction. Solution changed to r- 3445 of 1Ω, it was open. OK		jaironuness
PHILIPS	33PT578	Turning off by itself and heating the horizontal output	Electrolytic capacitor c-2455 - 47mf/25v with changed capacity	Capacitor replaced	Eletrônica Carlos - Salvador
PHILIPS	20PT120A L7L	Normal image after a few minutes the image becomes drizzled and disappears.	Ic 1002	Short the 100k r which is on pin 5 of ic 1002	Igor Almeida
PHILIPS	14 PT 110 L7L	TV turns on in service mode	Smd capacitor below the memory		Edson Peixoto