Philips Repair Tips
Search: philips
Results: 14210
Results: 14210
Make | Model | Symptom | Problem | Solution | By |
---|---|---|---|---|---|
PHILIPS |
TX2301
|
No remote operation - manual ok. | Tasqah (Bsa'ah) | ||
PHILIPS |
TX
|
No pic | 340v line to crt missing - lopt | ||
PHILIPS |
TX
|
Line down screen. | C455 ( 47u f ) leaky. | ||
PHILIPS |
TX
|
Frame - cramp - frame hold at one end. | Ts401 ( bc558 ) | ||
PHILIPS |
TX
|
Brightness uncontrollable - no frame. | O/c print in 95v line ( near ae socket bracket ) | ||
PHILIPS |
TVCR8218
|
Tv section dead | Replace wickman fuse, tda4505-3, 2 x 33k start up res & 1µ & 100µ in pri cct of psu | ||
PHILIPS |
TVCR8218
|
Trips | D6372 byw98/200 s/c | ||
PHILIPS |
TVCR240/05
|
Dead | R3584 47r fusible o/c, f1352 2.5 wickman fuse & d6351 byw98 (used byx55-600 in lieu) | ||
PHILIPS |
TVCR240
|
Dead - tripping; ht high | D6335 ugo6bp s/c pt no 4822 130 8330; r3343 5r6 safety res o/c 4822 052 10568, when replaced has excess brightness - r3592 10r o/c (supply to rgb) | ||
PHILIPS |
SA10EAA 28PW6816/05
|
Int changes chan on its own inc av & also int off | Main micro on sub panel with sm comps on it - known as "painter chip" faulty - costs around 50ukp & needs hot air soldering equip to change - not for the faint hearted! | ||
PHILIPS |
RC5903
|
Remote - faulty hand unit - its glued. | Remove name plate strip drill hole 1cm in from recess. | ||
PHILIPS |
NICAM 3A
|
Int blowing 800ma fuse f1642. | Increase to 1.25at. | ||
PHILIPS |
NC3-CR
|
Motorboating at first then a green raster. | Regulator 78m05 5v , check c2483 for dry joint. | ||
PHILIPS |
NC3-CR
|
Horizontal striations over screen. | C2413 ( 100uf , 400v ) o/c. | ||
PHILIPS |
NC3CR
|
Will not come out of standby - after new sw. | Low s/by contacts remain connected as long as mains do. | ||
PHILIPS |
NC3CR
|
No sound or picture after half hour. | Cnx62 optocoupler. | ||
PHILIPS |
NC3CR
|
Motorboating - green raster. | C2483 dry if so it may have damaged 78m05 5v reg. | ||
PHILIPS |
NC3CR
|
Distorted sound | R416 6.8r in 22v supply | ||
PHILIPS |
NC3CR
|
Dead - went bang - print blown off pcb. | Drys on mains on/off switch. | ||
PHILIPS |
NC3
|
Tuning indicator (green line) perm displayed | C371 100µ 16v s/c |