Philips Repair Tips

Search: philips
Results: 14231

Make	Model	Symptom	Problem	Solution	By
PHILIPS	21PT8467/78	Turns on normally with sound but no image, the channel appears, the volume but does not produce the image	R.3442	Replace r3442 from 100k next flyback	Rosivaldo
PHILIPS	42PFL3604/78	Turns on after a few seconds, turns off the screen, leaving only the sound	Faulty inverter power supply	Replace the rw 977 trimpot, which can be replaced by a 15k resistor. In my case, I just had to replace it, first measure the rw 978, if it is replaced, the value can be replaced for a 220r resistor.	AGILDO MENDES (MENDES ELETRONICA)
PHILIPS	55PUG6300	Does not turn on LED does not light up	D9104	Replace diode	matieski
PHILIPS	42PFL3403	Remote control doesn't work	Check capacitor 2p10 (10uf 20% on LED/IR panel	It's the only ceramic capacitor on the remote control sensor board and just replace it and that's it.	orlando lott
PHILIPS	32PHG4900/78	Doesn't work	D9101 shorted to the power supply		Eliel Magno
PHILIPS	AZ9350	No sound on 2 output channels	Burned sound output ta8227p	I put the cd8227gp ready, the device started working again, how did it come out of the box?	Reis eletrônica
PHILIPS	29PT9467C/78	Image closed from the sides and turning off out of tune	Horizontal	Ceramic capacitor c438	Geronimo
PHILIPS	21PT5433/78R	Turns on, after 8s it turns off. If you change channels it stays on, but be careful it could burn the horizontal output transistor	D6624(bas316)smd / c2428/	Replace d6624 with 1n4148	Cavaleiro Elétrico
PHILIPS	14PT3131	When turned on, the horizontal does not oscillate, but the STBY LED lights up when turned off on the control, +b with 94v.	1r resistor position 3445		Matões Assistência Técnica
PHILIPS	29PT4640	Does not oscillate, tsound are voltages, LED lights up and goes out on the control	Bc337 (7461)ou cap 47uf/50v	To replace	Lucas silva
PHILIPS	21PT5433	Tsound was no sound, just a good image	C2446 470mf for 16v buchudo	I put another one on, the TV looked like it left the store	Reis eletrônica
PHILIPS	20PT3331/78	This TV arrived in the electronics, it turns on with a sizzling and surper power power supply, heating up the 5563 coil and the screen sparkles and the image blinks and wants to close.	C2564,c2405 eo ic7515	Replace the c2405 and c2564 of 47μF250v and the coupled photo replace without measuring and that's it, the TV will work normally. God be praised!	Sinailson furtado
PHILIPS	FWM653	Mute, or cuts the sound randomly.	12 volts going to the amplifier board failing	Check circuit that switches this voltage, q608 q609, associated resistors and capacitors.	davi.sls
PHILIPS	32PFL3606	Inoperative, doesn't turn on, but suddenly turns on out of nowsound and also goes out out of nowsound	Cold solder chopper trafo and several points with cold solder on the power supply board	Cold solder at several points on the power supply board, and mainly on the power supply chopper transformer.	Vanderlei
PHILIPS	14PT3131	TV turns on after 5 seconds and turns off	R3475 open		Plasvideo
PHILIPS	14PT3336	Horizontal lines at the top of the tube	Capacitor 2460 of 68k x 100v change without measuring, the electronic capacitor. 2465 of 10mf x 250v also causes a similar defect		gilson eletronica
PHILIPS	FWM 663/78	Display completely off.	R14 on the power supply board burnt out	Replace the part	Daniel
PHILIPS	32PFL3404/78	Turns on with sound, no shine	Cf1 of 220pf/1kv, parallel with df1, modified	Swap cf1	Gabriel GXP
PHILIPS	HTB5580X	Just stby, tsound was no 12v, only 6 volts appeared	Optical coupler u509 faulty at the power supply		ELETRÔNICA MONTREAL
PHILIPS	40PFG5000 STPM15.5L LA	Gray screen with no image, LEDs ok!	Capacitor cd33 on the tab bar shorted	Tsound are several capacitors on the same line, I discovered the one responsible through elimination by individual testing.	Rui