Philips Repair Tips

Search: philips
Results: 14231

Make	Model	Symptom	Problem	Solution	By
PHILIPS	48PFG6110/78	Doesn't start	Short cut fast smd diode	The replace of the same	Airton Filgueira
PHILIPS	21PT9467	Turning off after turning on	Defective computer	Sorry, the way to place the diode in the previous post is wrong, correcting it, placing the diode in4007 anode pin 36 cathode to ground, it will keep pin 36 at 0.7 volts and it will no longer turn off	HP ELETRONICA
PHILIPS	21PT9467	Turning off after turning on	Defective computer	Place diode 1n4007 cathode pin 36 anode on ground, it will keep pin 36 at 0.7 volts and it will no longer turn off	HP ELETRONICA
PHILIPS	42PFL3508G	Doesn't start	Capacitor c9169		Tec Center
PHILIPS	FWM2200X/78	Low clicks in the boxes,	Change 50v 1000uf capacitor, close to the box connectors		Ronaldo bylu
PHILIPS	42PFL3604	Doesn't start	No standby voltage, LED off, no signal	Check the primary coil (in my case it was broken), replace the 4.7μF x 450 v capacitor, it was swollen. After replacement it started working again!	Augusto Azeredo
PHILIPS	32PFL5607D/78	It doesn't turn on, it just stays on standby, the LED lights up white and goes to red	Normal power supply voltages, grounded stand by pin, black light comes on and generates all voltages	I did a reset, holding volume + and the arrow key (input) while plugging it into the socket, it worked normally after that.	ser-mga
PHILIPS	FWM416/78	Shows disc reset fall when inserting the usb pen driver	Lack of reset on the CD due to lack of power	Causes capacitor 168 to short on the 8v line. After changing the capacitor, the 8v came back and the device rang normally
PHILIPS	40PFL9605D ?	The TV turns on, the image appears and then it turns off, only the sound remains.	Guys, the cause is q702 and q703, these two transistors are responsible for the switching of the transformer that feeds the 185 volts to the LED bars, I replaced the two fets and everything was resolved.	Replace the two fets q702 and q703 that were leaking and everything is resolved, let's stop being selfish and help others.	<small>This email address is being protected from spambots. You need JavaScript enabled to view it.</small>
SOM PHILIPS	FWM210	Display does not show characters	After evaluating the board, I noticed that tsound was no 10 volts (I put a 560 omhs resistor on the r524 that tsound was no board and the sound started working again		eletronica max es
PHILIPS	14PT414A	Does not turn on, power supply less than 20v	C2540 100µ 25v	Changing the c2540 close to the power supply trimpot	Marcelo Piranga
PHILIPS	FX30X/78 FX30	Doesn't start	N channel mosfet (q13) does not switch the +5va to the panel.	Replace the component.	barcelos32
PHILIPS	32PFL3008	Dead	C709 smd na pci main	I took it out	Adrian Chapadão do Céu Goiás
PHILIPS	40PFG6110 TV 715G6677-P02-001-002H	Did not turn on inoperative	Power outage	Smd diode d9311 short swap	Júnior eletrônica
PHILIPS	32PFL5604	In my case the defect was in c120, on the screen board. dismantle the screen to gain access. replace c 120, short.	Check "t-com" board voltage at c60,61= 0v, it must be 26v. see c110,115=0v, it has to be 16v.	In my case the defect was in c120, on the screen board. dismantle the screen to gain access. replace c 120, short.	arock
PHILIPS	32PFL3404	Turns on and after a while it turns off or the relay keeps hitting	Troque na placa principal.. c474, c532, c534	C474, c532, c534	José Oscar da Silva
PHILIPS	32PFL3404	TV turns on and off or the relay keeps hitting..	C474 defect on main board	Replace c474 na 4.7 aluminum main plate..	José Oscar da Silva
PHILIPS	39PFL4707G	Nothing turns on, not even the STB LED	Voltage of 5v with approximately 2.5v	Replace the power supply capacitors on the 5v line
PHILIPS	NTRX700	Very low sound	R 304 100r burned and diode d303 shorted	Just replace and run to the crowd	Wenceslau
PHILIPS	32PFL3008D/78	The LEDs turned on and off.	I changed the memory and it was upside down.	I solved it with code. 062598 + little house + 002 I will deliver to the customer	PIG QUILES