Philips Repair Tips

Search: philips
Results: 14206

Make	Model	Symptom	Problem	Solution	By
PHILIPS	43PFG5000	No image with sound and backlight on	I saw some tips sound on the forum and most of them said it was the c216. I looked on the ruler on the right side with the TV lying on the counter and I couldn't find it, I just found the c218 and when I removed it I found the short	To find out if the defect is in the t-con or the tele board, you must first check the voltages on the t-con board, vcc vgh and the others, close to the flat on the right side, if it is zero, remove the cables and take the measurements that will appear because this shorted capacitor was killing the t-con voltage	marco.320
PHILIPS	20PT3331N/78R L03.1L AA	The TV has a normal image, but the sound is very low on the speaker...	The diode was removed: 6908 (zener smd bzx384-c2v7), and replaced, the c2444 had a low esr, after the change the TV came back with normal sound	... then it was just a matter of hugging!!!	ENDEL NEIVA
PHILIPS	42PFL3507D	With sound but without image	Capacitor in t-con position (c209) and t-con fuse (f1)		Mario Moreci
PHILIPS	220TS2L	When I activate power, it turns on standby and then goes out.	Cause: c910 1000µf/10v on the power supply board, near the output harness		Lucas
PHILIPS	FWM653	I'm sound	Does not arm the amplifier power relay	D904 shorted	DiegoDLA
PHILIPS	21PD5932	Doesn't read dvds	Optical drive	In this case, it uses the SFHD 60 but you can use the SFHD62	DR.Luan Vintage
PHILIPS	21PD5932	Takes time to load dvd	Check capacitors on the dvd power supply board and the main	In my case it was the capacitors on the main board that were all dry.	DR.Luan Vintage
PHILIPS	20GL1045 20	TV with sound and no image	Open 2010 capacitor and cold solder.	Replace the 2010 25v 100μF capacitor and resolder the board.	Trafo elêtronica São Geraldo MG
PHILIPS	42PF9945	Power LED (red) lights up but does not turn green, the TV does not turn on.	Check the two 68r/5w resistors in the power supply		Mário Martins
PHILIPS	40PUG6300/78	Dead doesn't start at all	Short smd diode	Replace shorted diode on the q9303 line	Vital eletrônica Hawaii 12
PHILIPS	14PT314A/78R	When changing the fly_back the TV worked normally but after a few minutes it started to turn off intermittently and also when pressing the volume key the TV entered the menu	Q7611	Just make a jump on the base and collector of the 7611 smd transistor and the TV will work normally. Praise be to God!	Sinailson furtado
PHILIPS	14PT314/78	When plugging the TV into the socket, the stand bay light no longer turns on. The TV in the armpit generates a very weak high voltage. When adjusting the screen to the maximum point, a horizontal line appears at the bottom of the screen.	C2551 and c2409	Replace without measuring the c2551 is the c2409 of 47μF160v and that's it, the TV will work normally.	Sinailson furtado
PHILIPS	NTRX500 NTRX700 NX5 NX7	Blinking LEDs wouldn't turn on	Change the 5 electrolytic capacitors around the ci smd u501 on the panel board, 1 capacitor 100/10v+4 47uf be careful because the tracks break in the solder they are very thin		eletronica junior reginaldo moronte
PHILIPS	29PT9467	Cushion effect	Q440 (irf630) shorted and 6.8r region 440 open	Replace both	Laercio
PHILIPS	32PHG410978	League has sound but no image	After checking everything and thinking it could be the negative led bars	The problem was with the output of the black lights socket, it was the IC that triggers the LEDs in shorts, it is close to the connector and it is the only one with 3 large legs on the power supply board and just replace it and go to dim dim	ELETRONICA PUBLISOM DE NATAL RGN
PHILIPS	48PFG6110/78	Doesn't start	Short cut fast smd diode	The replace of the same	Airton Filgueira
PHILIPS	21PT9467	Turning off after turning on	Defective computer	Sorry, the way to place the diode in the previous post is wrong, correcting it, placing the diode in4007 anode pin 36 cathode to ground, it will keep pin 36 at 0.7 volts and it will no longer turn off	HP ELETRONICA
PHILIPS	21PT9467	Turning off after turning on	Defective computer	Place diode 1n4007 cathode pin 36 anode on ground, it will keep pin 36 at 0.7 volts and it will no longer turn off	HP ELETRONICA
PHILIPS	42PFL3508G	Doesn't start	Capacitor c9169		Tec Center
PHILIPS	FWM2200X/78	Low clicks in the boxes,	Change 50v 1000uf capacitor, close to the box connectors		Ronaldo bylu