Philips Repair Tips
Search: philips
Results: 14245
Results: 14245
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| PHILIPS |
ANUBIS A
|
Dead ht at only 20v instead of 95v if plug m5 rem | D6555 in 5v supply leaky | ||
| PHILIPS |
ANUBIS A
|
Dead apart from whistle | Loptx - tested ok on oz loptx tester | ||
| PHILIPS |
ANUBIS A
|
Dead , but11 sc. | Use service kit sbc7021 pt no philips 4822 310 20491 | ||
| PHILIPS |
ANUBIS A
|
Dead - ht low at 40v (95v) | Tr7537 sm bc848c error sense tr leaky | ||
| PHILIPS |
ANUBIS A
|
Dead - ht being dragged down by lop stage | Resistance of 20r across loptr - loptx faulty at2079/40 -tfhr7488 (cpc) | ||
| PHILIPS |
ANUBIS A
|
Bright raster with flyback lines. | Break in print on crt base. | ||
| PHILIPS |
ANUBIS A
|
Blank raster no sound osd works signal fed via fro | Unit in external mode check pin 18 ic7015 if high check all jumper leads around scart socket | ||
| PHILIPS |
AA5AB 21PT165B
|
Overbright raster, with flyback lines | R3470 8r2 o.c. (safety resistor to 183v supply from l.o.t.) | ||
| PHILIPS |
AA5AB
|
Line collapse | 680nf cap in line o/p stage low cap | ||
| PHILIPS |
AA5 AB
|
No response to r/c commands | St24c02cp eeprom chip | ||
| PHILIPS |
AA5 AB
|
Line o/p tr failure | Dry joints rear connector of scan coils | ||
| PHILIPS |
AA5 AB
|
Line collapse then off | C2450 680nf 150v s corr cap | ||
| PHILIPS |
AA5 AB
|
Dull pic aft replacement of tda8362 or crt base components | R3470 8r2 safety res in rgb ht supply o/c | ||
| PHILIPS |
AA5 AB
|
Dead with leds flashing on/off every 3 secs | Eeprom fault - new st2402a made no difference, neither did lm317t reg which had no o/p - crack in print pin 1 loptx | ||
| PHILIPS |
AA5 AB
|
Dead no st/by unless line stage dis'd | Loptr bu1508dx 7445 pt no 4822 130 63569; loptx 5445 pt no 4822 140 10544 | ||
| PHILIPS |
AA5 AB
|
Dead - wickman fuse 1571 o/c | When replaced ht low & tripping. lopt u/s. if fuse blown for no apparent reason philips say change thyristor 7481 & 3482 sm resistor 6k8. | ||
| PHILIPS |
AA5 AB
|
Dead - no line drive pin37 ic7015 tda8361 | Chip faulty | ||
| PHILIPS |
AA5 AB
|
Dead - burn up &/or s/c rgb trs on crt base or ic7015 tda8362 on main pcb damaged | Loptx is main suspect of this fault | ||
| PHILIPS |
AA5 AA
|
No field scan | Tda3654 7401 & d6449 byd33g & 3449 400ma wickman fuse | ||
| PHILIPS |
AA5 21PT166B
|
Dead with ht loptx pri | Prot 1571 o/c in series with 11v supply to 8v reg ic7567 which had s/c o/p.this feeds pin 10 multifunction chip ic7015 via l5565 which was s/c to chassis. usually caused by breakdown in loptx |