Philips Repair Tips
Search: philips
Results: 14245
Results: 14245
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| PHILIPS |
ANUBIS-A
|
All leds in display blinking. | Check lot 5445 (4822 140 10406). | ||
| PHILIPS |
ANUBIS-A
|
After a while no picture. only sound. txt and osd are ok. | Check whether dc voltage pin 11 ic7280 (tda3504) is 3v. if not, check/replace c2255 (100nf; 4822 122 33496). | ||
| PHILIPS |
ANUBIS-A
|
Afc control is slowly. station unstable. | Check tuner (uv917/iec; 4822 210 10405). | ||
| PHILIPS |
ANUBIS-A
|
50 hz humm at loudspeakers in stand-by | In case of a 50 hz humm at the loudspeaker in stand-by of a 3w anubis a set, it is recommended to replace: sops transformer 4822 148 60299 (dedicated for 3w anubis a sets) at itemnumber 5525. remarks: the ripple of the +13 supply voltage coming from the | ||
| PHILIPS |
ANUBIS-A
|
+ 95v is too low. | Check/replace ts7445 (but11af;4822 130 42679). | ||
| PHILIPS |
ANUBIS B-AA
|
When replacing eeprom ic7685 st24c02p | Default language is norwegian! & childlock (barnlas)active. to clear childlock select spec functs option c on main menu. next menu - barnlas as option a - set to fran (off). then able to set up other parameters | ||
| PHILIPS |
ANUBIS B-AA
|
Removing "demo" mode | Switch on whilst holding in "vol-" & "prog+" in together. | ||
| PHILIPS |
ANUBIS B-AA
|
Led flashing with "er4" displayed | Fault in txt - lines only in txt - xtal 1701 27mhz faulty | ||
| PHILIPS |
ANUBIS B-AA
|
Hor grey line over pic | Field scan has osc on it - c4213 10nf o/c | ||
| PHILIPS |
ANUBIS BAA
|
Dead with pulsing squeak | C2540 2200µ 16v leaky | ||
| PHILIPS |
ANUBIS B AA
|
Dead - chopper tr s/c | Replaced opto ic7514 cnr50, control chip ic7500 & chopper tr | ||
| PHILIPS |
ANUBIS B
|
Works but led flashes and e4 on screen + no text | 27mhz xtal on text pcb | ||
| PHILIPS |
ANUBIS B
|
No txt | 27mhx xtal | ||
| PHILIPS |
ANUBIS B
|
No e-w corr | R3404 47r in module 110 panel o/c | ||
| PHILIPS |
ANUBIS B
|
If ic7685 replaced set will display norwegian and | Menu set "barnlas" to "fran" ( off ) then set may be reset | ||
| PHILIPS |
ANUBIS B
|
Horizontal grey line on screen | C2413 10nf in field cct | ||
| PHILIPS |
ANUBIS B
|
Er4 displayed on screen - no text only lines. | 27mhz crystal 1701. | ||
| PHILIPS |
ANUBIS A-AC 17PT166A
|
Dead - in shutdown mode | S/c across loptr coll & emitt - not loptx this time but c2450 330nf 250v scan coupling cap s/c | ||
| PHILIPS |
ANUBIS A-AC
|
Ok until put into st/by when led flashes with thumping noise | D6568 llzf6v2 leaky in st/by cct | ||
| PHILIPS |
ANUBIS A-AC
|
Flickers on high brightness with drop in ht | Tr7554 bc337a leaky |