Philips Repair Tips
Search: philips
Results: 14245
Results: 14245
Make | Model | Symptom | Problem | Solution | By |
---|---|---|---|---|---|
PHILIPS |
ANUBIS-A
|
Totally inoperative. | Replace line transistor t7445 but11af by bu1508dx (4822 130 63569) | ||
PHILIPS |
ANUBIS-A
|
Totally inoperative. | Check track between pin 1 lot 5445 and collector of t7445 on interruption. | ||
PHILIPS |
ANUBIS-A
|
Timer not ok, no 10min/20min etc. | Replace ic7600 by new software version tmp47c834n-r165 (4822 900 10508) | ||
PHILIPS |
ANUBIS-A
|
Supply in protection. | Check/replace lot (l5445; 4822 140 10406) (short circuit between several coils). | ||
PHILIPS |
ANUBIS-A
|
Squeeking sound from ctv chassis. | Check/replace lot l5445 (4822 140 10406). check for short circuit between coil 7 and 4 of lot. | ||
PHILIPS |
ANUBIS-A
|
Sometimes "txt - error" | Replace x-tal x1710. | ||
PHILIPS |
ANUBIS-A
|
Sleep-timer timer skips 1 minute every 10 minutes. | Replace item 7600 with new software tmp47c834n-r165; 4822 900 10508. remarks : introduced in production in week 9413 or 9420 depending on the version | ||
PHILIPS |
ANUBIS-A
|
Set still defective after replacing sops repair kit | Check/replace thyristor 6570 (sfor5d43; 4822 130 20245) and d6569 (ll4148; 4822 130 80446). remarks :sops repair kit is sbc7021; 4822 310 20491. | ||
PHILIPS |
ANUBIS-A
|
Set shuts off sometimes. leds blinking. no output from pin 29 ic701 | Wire b42 from r3053 too c2354 was mounted too strong around tuner. whith damaged isolation. | ||
PHILIPS |
ANUBIS-A
|
Set is motorboating after 15 minutes. | Check c2545 (4u7/100v; 4822 124 40769). | ||
PHILIPS |
ANUBIS-A
|
Set is motorboating after 15 minutes. | Check c2545 (4u7/100v; 4822 124 40769). | ||
PHILIPS |
ANUBIS-A
|
Set "motorboating" when in standby. | Transistor 7553 was found to leaky b-e, type bc858a 5322 130 42012. | ||
PHILIPS |
ANUBIS-A
|
Search does not stop; pin 12-ic7015 is ca. 2v. | When the search stopped the picture is out of synchronization, check/replace d6370 (llz-f12; 4822 130 82304). | ||
PHILIPS |
ANUBIS-A
|
Repeat repair after defective mains fuse 1500 | In case only the mains fuse 1500 (4822 070 32002) is replaced to repair an anubis-a set, it is strongly recommended to replace the ptc 3501 (4822 116 40137) also. especially ptc's with printed weeknumber 317, 341, 346 and 406 can be damaged in case the f | ||
PHILIPS |
ANUBIS-A
|
Random e3 displayed at start-up | Change the following component: position: c2560 680uf into 1000uf 4822 124 40214 r3452 10r into 1r0 safety 4822 052 10108 r3782 12r into 18r 4822 053 | ||
PHILIPS |
ANUBIS-A
|
Programs lost after initial programming of replaced eeprom | If after eeprom replacement the programms stored in system france disappear after the switch-off, this is because the osd showed system france but the microprocessor was in system europe (due to a software bug) the solution is to do after eeprom replacem | ||
PHILIPS |
ANUBIS-A
|
Poor tuning; unstable picture | Check/replace d6052 (1n4148 ; 4822 130 30621)- status diode. check/replace d6370 (llz-f12; 4822 130 82304). remarks : the cure is applicable for poor tuning and for unstable picture, afc hunting type fault, when a picture is present. | ||
PHILIPS |
ANUBIS-A
|
Poor colour sync | The following production changes have been introduced: 1) from week 9136 : capacitor c2267 (100nf) is changed to 150nf 4822 122 33812 and capacitor c2268 (47nf) is changed to 22nf 4822 126 11544. 2) from week 9148 : a 100nf capacitor 4822 122 | ||
PHILIPS |
ANUBIS-A
|
Poor colors, pal lines | Check/replace delay line ic7221 (tda4660; 4822 209 63108). | ||
PHILIPS |
ANUBIS-A
|
Picture pulses when remote control handset used. h.t low at 92 volts | C2557 4n7 was found to read 20 kΩ. 4822 122 31784. |