Philips Repair Tips
Search: philips
Results: 14231
Results: 14231
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| PHILIPS |
21PT5433
|
High power supply and turns off gun protection | R3519 changed 3k3, it was 34k | To replace | Dj Velk |
| PHILIPS |
32PFL4007D/78R
SN |
TV won't turn on, 5v voltage only gave 1.2v and 0.5v varying | Defect in pci power supply ci a6069h 5vdc power supply converter | Ic replacement | Paulo Pinho |
| PHILIPS |
16GL1033
GR1-L1 |
Insufficient width, with normal image | Open 6512 diode | Replace with another equal or equivalent fast cut-off diode | ELVONEUTON FRAGA CAETITÉ BAHIA |
| PHILIPS |
NX5
POW1200B |
Doesn't start | Rectification diodes d7 and d8 open without voltage +12 / -12 / +5v / standby | Replacing sb3100 diodes with μF5802 | Francelino |
| PHILIPS |
FWP2000X/78
|
Tsound is no sound on the fm and mp3 link input. other functions all normal. | Ic 502 | Replaced, and everything went back to normal. | PATRIARCA |
| PHILIPS |
FWM663
|
Does not turn on, does not come out of stand by | Q8 open emitter | Janilson JD ELETRONICA CAETITÉ-BA | |
| PHILIPS |
FW-M922
|
Normal audio after a few seconds it goes down on its own until it becomes silent | Q7506 with c leak, the base needs to be below 0.60v otherwise it polarizes and takes the collector to 0v making the sound turn off, the microprocessor monitors this line and depending on the leak in the collector makes the processor turn off the power supply or lower the volume until stay mute. | antonio mb |
|
| PHILIPS |
14PT3336
|
Turn on the LED power when you turn on the TV, the LED turns off, the power supply voltage drops | R3445 1r open (-12v supply that powers horizontal oscillator) | º¿º | Alextecnico |
| PHILIPS |
FWM613X/78
|
Dead | No voltage from us IC606 (UTC7805) 5V and IC603 8V (UTC7808) | Replacement for D913 (IN5392), C931 (50V 330UF), C638 (16V 470UF) | Tico Celulares |
| PHILIPS |
26PFL3604
LCD |
Turns off in +/- 10 minutes. Sometimes it keeps turning on and off. | Ic901 tny277 heating up beyond normal. | Replace ic901 tny277 for tny289 blz | Pedrozo |
| PHILIPS |
FWM210/78
|
When you increase the volume, the audio cuts out | C590 and c591 | Remove c590 and | Marcelo Piranga |
| PHILIPS |
40PFG5109
|
No normal backlight image | C08 shorted on main board | Replace c08 | robdson |
| PHILIPS |
32PFL3008D/78
|
No sound on channels (RF) | Memory defect | Enter service mode through the menu (little box) 1 9 9 9 return go to reset and press ok, it will turn off, wait 15 seconds, turn on and that's it | eletronica fernandes - to |
| PHILIPS |
42PFL3403/78 32PFL3403/78
LC8.1L LA |
No audio on all video inputs (antenna, avs, hdmi no sound). but with normal audio on the headphone output. | Short-circuited capacitor, close to the 7411 audio modulator. | Replace of capacitors position (2420, 2423) value 10u x 16v. | rafaelmoraes99 |
| PHILIPS |
FWM998X/78
|
Tsound are clicks at the rear speaker outputs. | Check inductors l2 l3 | samuel leite | |
| PHILIPS |
20PT3331/78
|
Turns on without audio with noise in the speaker and jagged image | Capacitors 2564, 2405, 2444 | Replace of the same | AssisTec |
| PHILIPS |
29PT4635/78
|
Heated horizontally if it burns horizontally | Capacitor replacement 2455 47x25v | Capacitor replaced 2455 47x25v | <small> |
| PHILIPS |
32PFL3017D/78
|
Does not turn on, sometimes the LED blinks | The 5 volt supply is low | Replace the c9353 electrolytic without testing for 470×16v, and go for the hug.... | Paulo Sertel-Itararé Sp 2018 |
| PHILIPS |
32PF7520D/10
LC4.3E AB |
Doesn't work. power on led turns red but does not turn on | Power supply does not work, check 68ω/5w resistor on the power supply board | Andrade Sequeira | |
| PHILIPS |
TCI-A10S-B 94V0 TCI-A105-D 94V0
L03.1L |
I just ironed it and removed the solder and the TV turned on normally. | 3.8v missing on pin 17, it was 0v after a while I found the 2428 capacitor soldered with the 6426 diode | I just ironed it and removed the solder and the TV turned on normally. | genilson |