Search: philips
Results: 14206
Make Model Symptom Problem Solution By
PHILIPS 47PFL4007G
5v varying Leaky EA6 transistor Replace os transistor local u306 eo u304 eletrônica smart
PHILIPS 21PT739A/78R
Does not increase volume more than 7, only lowers it Corrupted eprom data CatracaBJ
PHILIPS 32PFL5604/78
TV does not turn on stand-by when switched off. Defect on the power supply board c220 and c221, both 220pf for 1kv completely toasted and the protection fuse open at 3.15a, I had to change it and get the money. ARMANDO DE OLIMPIA
PHILIPS FW452
Only on standby L554 on tray board geronimo lima
PHILIPS 24PFL3017
Has sound without image Ci pf7001s Replace the ci cleber lima rs
PHILIPS 42PFL3508
L12M3.1
Don't tune in Oxidation in tuner 1201 (water entered through the antenna cable) Clean oxidation or replace it T.CUNHA
PHILIPS HTS2500
Power led blinking Power supply c930 2,2uf160v Capacitor c930 2,2μF 160v nilson sakura
PHILIPS NX3
It works for a few minutes and cuts the sound. Remove "q20 and q22" from the amplifier board. Governor Valadares digital electronic credits. Erick e Ge.
PHILIPS 32PFL3404/78
Turns on, backlight turns on, the screen looks like a rainbow, starts red, yellow in the middle, white and dark at the bottom. After turning it on for a while, the screen is all blue and the image appears, everything is normal Check cb1 and cw 23. Swap cb1 cw23. arock
PHILIPS FWM6000X/78
No audio, but with all voltages present. On the side plate I found the coil l 605" 22uh" open, it supplies +b from the ci "u 602". After the replacement, the audio was pure beauty. good luck . This email address is being protected from spambots. You need JavaScript enabled to view it.
PHILIPS 32PFL3008D
Inverted image Enter the code 062598 box 0033 the image returns to normal samuel leite
PHILIPS 14PT218
Turns on and off in seconds R3417 .33k next to the flyback DJ PITUKA
PHILIPS FWT3600X/78
Turns on normally and has no audio Q2(svf12n65f) on the power supply PCB burned. Replace MB Eletrônica
PHILIPS 43PFG5000
TV turns on LED bar and no image appears Ceramic capacitor c208 on the board that leads to the screen alexandre
PHILIPS 32PFL3008D/78
Turn on LEDs but the screen does not show an image. Then turn off the LEDs Cause of the memory defect with poor contact and just remove it from its place and clean the place and then replace it again and go for the hug.. Diego lima. nova TIMBOTEUA para
PHILIPS FX50X/78
The LEDs turn on, the display does not light up and it does not work Smd diode s7 short Replace with a fast 1n4937 power supply diode Dj Velk
PHILIPS 14PT414A/78
Tsound is no image in the av just the sound Diode 6116 diode shorted Edinaldo
PHILIPS 32PFL3403/78
Does not turn on or stand-by Main board. This defect is misleading because the main board that activates the power supply board relay activates the 3.3v from the ps-on. After checking the entire power supply board and finding nothing, I decided to test the main board and that was the defect. As I was already angry, I didn't even try to fix the main PCI. Multimídia
PHILIPS 32PFL3403/78
Turns on standby when activated on the control, turns on and then turns off Defect in the backlight board, the TV turned on and off and went into protection Replace of 680μF 35v capacitors c2 and c3. and f1 8a fuse Multimídia
PHILIPS 40PFL3605D
With sound without image 750k resistor replacement Signal board close to the 2j30 ceramic capacitor behind the board ajm