Search: philips
Results: 14252
Make Model Symptom Problem Solution By
PHILIPS TCI-A10S-B 94V0 TCI-A105-D 94V0
L03.1L
I just ironed it and removed the solder and the TV turned on normally. 3.8v missing on pin 17, it was 0v after a while I found the 2428 capacitor soldered with the 6426 diode I just ironed it and removed the solder and the TV turned on normally. genilson
PHILIPS 33PT574A
It doesn't turn on, the LED keeps flashing and the power supply oscillates between 60v and 120v and it doesn't start. Replacement of the 2540 100/25 capacitor Buiu57
PHILIPS 20PT524A
I'm sound Microns that are on the audio board. Luan LG Philips
PHILIPS 32PFL4017
No image, back light on Ci shorted on t-com board Replacement Roberto Costa
PHILIPS 14PT4131
Turn on and off Change smd diode 6460 and 6464 near the vertical transistor DJ PITUKA
PHILIPS 42PFL3507
Does not turn on completely inoperative Capacitor seco Replace c9353 power supply board T.CUNHA
PHILIPS 43PFG5000
Does not turn on inoperative dead power supply due to a raw C477 shorted on main board Replace it and that's it or leave it without orlando lott
PHILIPS 29PT5642
Cup effect Data loss Rewrite eprom eletronica bianca ipira-ba
PHILIPS 47PFL7008G
LED lights up and goes out. jam power supply to/test backlight R-100Ω on pins 2 and 4 (gnd1 and stb) and jumper pins 3, 11 and 13 (3v3s - blon - dim1 ) Back light coming on, confirmed that the main is bad INOVA
PHILIPS 14PT414
TV without sound with normal image Check a round fuse in position 1571 near the 1000/35v cover. This power supply goes through this fuse, from tsound it goes to the 2200/35v cover, follows the track, goes to the sound ci cover wsound it feeds it. Replaced the fuse, gives normal sound. fed the sound ci. <small>This email address is being protected from spambots. You need JavaScript enabled to view it.</small>
PHILIPS 42PFL3605D
No image with screen on and the 12v voltage on the display popping up even after turning off the lvds flats 750k resistor (7503) close to the 1m20 connector that goes to the keyboard, but under the board ADEMAR
PHILIPS 21PT6458S/78R
Missing one of the colors i.e. missing blue missing green or red Change all the RGB transistors that are on the tube board without testing When changing the transistors, put new ones, and place it away from the board. Luan LG Philips
PHILIPS 29PT4635/78
Jagged image when turning on and then off. C2455 dead Replacement Delfran Eletroeletronicos
PHILIPS 32PFL3008D/78
TV only turns on the black light and turns it off Flash memory Remove the memory from the board, clean it and return it to the board, this may solve it, if it doesn't, replace the memory. DJ João
PHILIPS 32PFL7606
Dark blue screen no image has sound Leaky capacitors on the v-com board Replace smd capacitors cleberlima rs
PHILIPS 21PT5435
Don't call, sometimes you do! C2524 2.2 100v burst or leak Replace it and that's it orlando lott
PHILIPS 20GL1049
The TV turned on, showed the image, menus acting normally with universal control, but the volume was at maximum and wouldn't go down. It was thought that it was a bad memory. However, a jammer was found between the numbers 3961, 2605 and 9971 on the plate, which had one side loose due to rust. With the resoldering, turning on the respective track that passes through it, when the TV turned on, the volume control worked. God is faithful. <small>This email address is being protected from spambots. You need JavaScript enabled to view it.</small>
PHILIPS 20PT3331
Without image, with sound and characters appearing Resistor r2442 150k next to the open fly back Replace and run to cocoa digital system
PHILIPS 40PFL7606
Turns on, backlight turns on but tsound is no video...normal sound This email address is being protected from spambots. You need JavaScript enabled to view it. I reflowed the main board processor and started it at 200 degrees and then a minute at 300 with a rework station..it went back to normal Fabio Marinelli Eletrônica
PHILIPS 32PFL5604
TV turns on without backlight sound ok note; When turned on, a faint glow appears and then goes out. Defect in the cf1 221k 1kv capacitor at the power supply with leakage. Replace it and move on to another. celso