Philips Repair Tips
Search: philips
Results: 14206
Results: 14206
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| PHILIPS |
14PT3131/4131/3331/4331
|
With vertical bar(s) or stripes | - change capacitor 2447 to 4.7µf/250v code 2022 031 00137 | ||
| PHILIPS |
14PT3131/4131/3331/4331
|
Excessive shine | - verificar resistor 3300 (33k) panel trc. | ||
| PHILIPS |
14PT3131/4131/3331/4331
|
Poor brightness (little shine). | Check possible alteration of resistor 3206 (1k). | ||
| PHILIPS |
14PT3131/4131/3331/4331
|
Appears dos/menu/characters/message - flashing. | If the power supply uses the FET transistor fqpf7n80 in position 7521, the TV has difficulty turning on, sometimes it turns on and shows the message: err 576lo3lsi2.2 00000 000 192 064 224 072 000 080, capacitor 2585 must be eliminated. | ||
| PHILIPS |
14PT3131/4131/3331/4331
|
Appears in the / menu, however, without an image. | Check possible alteration (open) of resistors 3441 or 3442. | ||
| PHILIPS |
14PT3131/4131/3331/4331
|
Appears in the / menu, however, without an image. | Check possible change in resistor 3449 (27k) | ||
| PHILIPS |
20PT3331
|
Vertical with retraces at the top, does not accept remote commands | 10ux160v(c2465) e transistor smd q7466 (vertical)e micro chave | Replace c and transistor clean micro-switch | |
| PHILIPS |
14PV162
|
Calling installation menu | The installation menu is activated by the following procedure: - switch on the set by means of the stop key. - press simutaneously the cursor left and the cursor right key on the remote control. | ||
| PHILIPS |
14PT156B
|
No pic (field collapse) - sound ok | R3449 4r7 feed res to fop chip o/c - no other fault detected | ||
| PHILIPS |
14HT3303
|
Service code of the fm-radio tuner. | In the partslist of the radio-sp/ls-vbatt panel of the chassis manual l9h.2e, the service code of the fm-radio tuner item 1901 was not indicated. the service code is 9352 632 70112 | ||
| PHILIPS |
14CN3001/05
|
Int low contrast | Check preset res (chan scan) isn't shorting to crt aquadag | ||
| PHILIPS |
14CN2201
|
Dead - correct 100v ht on dummy load | Scan coils - had arced across rubber wedge | ||
| PHILIPS |
12TVCR240/05
|
St/by only - no line drive | Ug06b clamp diode leaky | ||
| PHILIPS |
12B312/15S
|
Dead. | Drys on sub pcb & bu type regulator. | ||
| PHILIPS |
10CX1120/05R
|
Power supply working but no line drive. | Changed the following t539 / t534 / r537 / r502. lopt faulty | ||
| PHILIPS |
10CX1120/05
|
Raster - distorted & no frame sync. | Ske bridge recy. | ||
| PHILIPS |
10CX1120/05
|
Dist raster & no field sync at sw on - clears aft 10 mins | Mains bridge rect int goes o/c | ||
| PHILIPS |
10CX1120/05
|
Dead - micro tms3757anl-10 | T273 bc557 s/c in av/rf sw cct also | ||
| PHILIPS |
10CX1120
|
Servicing the philips 10cx1120 | See tv mag jan 1995 | ||
| PHILIPS |
10CX1120
|
Field scan erratic with cramping across centre | C582 10nf ceramic cap leaky - pin 20 tda1770 |