☰

Philips Repair Tips




AIWA
BEKO
CCE
CINERAL
DAEWOO
FUNAI
GRADIENTE
GRUNDIG
HITACHI
ITT
JVC
LG
MITSUBISHI
PANASONIC
PHILCO
PHILIPS
PIONEER
RCA
SAMSUNG
SANYO
SHARP
SONY
THOMSON
TOSHIBA
VESTEL


Search: philips
Results: 14251
Make Model Symptom Problem Solution By
PHILIPS 16GL1033
Acts protection R3342-8k2 r3346-18k r3319-100k alterados Replace r3342 of 8k2 r3346 of 18k and r3319 of 100k
PHILIPS 20GL1040
Bad image, tuning varies, and when changing channels, the horizontal drops C195 470x16
PHILIPS 14PT3131/4131/3331/4331
High or low Low voltage change r3526 (at 110v it doesn't work and at 220 it works with voltage below 65v on +b)
PHILIPS 14PT3131/4131/3331/4331
Volume from minimum or maximum. - check circuit to eliminate "plop", mainly diodes 6908, 6909 and capacitor 2909.
PHILIPS 14PT3131/4131/3331/4331
Volume does not go down completely. - check possible alteration of diode 6906 (1n4148), probably open.
PHILIPS 14PT3131/4131/3331/4331
Vertical closing intermittent. - check capacitor 2464.
PHILIPS 14PT3131/4131/3331/4331
Vertical closing intermittent. - verificar service information ts04-016.
PHILIPS 14PT3131/4131/3331/4331
Vertical closing intermittent. - check capacitor 2461 (1nf).
PHILIPS 14PT3131/4131/3331/4331
Vertical closing intermittent. - check capacitor 2460 (see service information ts04-016).
PHILIPS 14PT3131/4131/3331/4331
Vertical with little amplitude - check transistor 7461, replace if in doubt.
PHILIPS 14PT3131/4131/3331/4331
Vertical with little amplitude 250v) code 2222 479 47207 (see service information ts04-016).
PHILIPS 14PT3131/4131/3331/4331
Vertical with little amplitude - check capacitor 2460 (68nf 100v), temporarily the capacitor will be damaged by heating, in this case the stations are being advised to replace the capacitor with (68nf
PHILIPS 14PT3131/4131/3331/4331
Voltages below the specified (vo, +b,..) - check possible alteration of resistor 3453.
PHILIPS 14PT3131/4131/3331/4331
Voltages below the specified (vo, +b,..) - check possible changes in the 1k 3525 smd resistor connected to pin 9 of the ci 7250.
PHILIPS 14PT3131/4131/3331/4331
Voltages below the specified (vo, +b,..) - check possible changes in the 1k 3525 smd resistor connected to pin 9 of the ci 7250.
PHILIPS 14PT3131/4131/3331/4331
Voltages below the specified (vo, +b,..) - g2 does not work, check 5441 tsh.
PHILIPS 14PT3131/4131/3331/4331
Voltage varying. - check possible alteration of transistor 7523 or 7515.
PHILIPS 14PT3131/4131/3331/4331
Voltage varying. - check possible changes in the 1k 3525 smd resistor connected to pin 9 of the ci 7250.
PHILIPS 14PT3131/4131/3331/4331
Dark screen - no image or active progressive - check ci 7641, in this case it should show normal dos.
PHILIPS 14PT3131/4131/3331/4331
Dark screen - no image or active progressive - check the possibility of altered/open resistors 3443/3444.