Search: philips
Results: 14238
Make Model Symptom Problem Solution By
PHILIPS 14GL1316
Does not tune channels; with normal tuning voltage and characters. After changing the varicap without success, I checked the t7100 [band switching] and found that it was leaking. After changing it, the TV started working normally again.
PHILIPS 20GL 1043
Check resistor 3321, it usually opens easily and then diode 6340, 15v zener with leak
PHILIPS 20PT 120A / 78
Stand by LED is on, when the remote is activated it reacts by flashing and stays on again. voltage +b normal. Troque fly back
PHILIPS VR799
It doesn't start, only the clock appears and a line on the side, it's in the lock key Hold down the power key for 10 sec on the remote
PHILIPS 20CT6055
Just sprinkles R103
PHILIPS 20GL
Sometimes it called, sometimes it didn't. Replace the flyback and the horizontal output. The fly winding causes a short and the horizontal output is damaged.
PHILIPS 7CM5279
Clear screen with retrace lines R3570 (0,68 r)
PHILIPS 4CM5299
Image ok at 640x480 but shifts to the right at 800x600 Replace c2505 3.3 uf by 4.7 uf. located not pine 10 of ic7502 (hef4538 mode detector)
PHILIPS 4CM5299
Image too wide Check bd677
PHILIPS 3CM9609
Dead R3121 (270 k 1 w)
PHILIPS 201B10
No horiz sync when changing resolution C2431 (150 nf 63v)
PHILIPS TAPE-DECK 06AC060
Dead on a channel Ts432a, ts432b, c760 e r606
PHILIPS TAPE-DECK AW-620
Play does not work Ts461 (bc328)
PHILIPS TAPE-DECK AW-620
LEDs off D363 (zener 8,2 v 400 mw)
PHILIPS VR-457/78
Dead open f901 Cp1101 (fuse link icpn15), d955, q901 (2sk2129)
PHILIPS VR-453
Reproduction without color Cold solder on pin 26 of ic601
PHILIPS 3106-106-TX
No vertical deflection C509 (4,7 nf)
PHILIPS 12 TX 1572
Unstable vertical deflection C527 (100 µf 35 v)
PHILIPS TVC/20CT
Dead C355 (470 nf)
PHILIPS R22 K210
Dead Vl603 fuse holder