Philips Repair Tips
Search: philips
Results: 14206
Results: 14206
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| PHILIPS |
14PT100G/78R
|
Just sprinkles | R3009 (180Ω) aberto | ||
| PHILIPS |
28PW858
|
Stand-by after 1 hour on | Ssb board rewelding | ||
| PHILIPS |
20PT220A
|
LED blinking non-stop | Non-micro cold welding | ||
| PHILIPS |
29GX858
|
Dead | Elect. 4.7uf circ standing plate. oscillator.. | Elect. 4.7μF circ standing plate. oscillator. | |
| PHILIPS |
14GR1222/87R
|
Does not light | Transistor c3795b saida horizontal | ||
| PHILIPS |
20GL1045/78R
|
Acting in tune | |||
| PHILIPS |
29PT554A
|
Inoperative, you can only hear clicks in the speaker. | Replace blue c2550 cap 471 which is shorted. Note: there are no voltages on the power supply secondary. | ||
| PHILIPS |
20CN4469
|
When switching on, the indication f1 appears on the display. | |||
| PHILIPS |
14GL1316
|
Does not tune channels; with normal tuning voltage and characters. | After changing the varicap without success, I checked the t7100 [band switching] and found that it was leaking. After changing it, the TV started working normally again. | ||
| PHILIPS |
20GL 1043
|
Check resistor 3321, it usually opens easily and then diode 6340, 15v zener with leak | |||
| PHILIPS |
20PT 120A / 78
|
Stand by LED is on, when the remote is activated it reacts by flashing and stays on again. voltage +b normal. | Troque fly back | ||
| PHILIPS |
VR799
|
It doesn't start, only the clock appears and a line on the side, it's in the lock key | Hold down the power key for 10 sec on the remote | ||
| PHILIPS |
20CT6055
|
Just sprinkles | R103 | ||
| PHILIPS |
20GL
|
Sometimes it called, sometimes it didn't. | Replace the flyback and the horizontal output. The fly winding causes a short and the horizontal output is damaged. | ||
| PHILIPS |
7CM5279
|
Clear screen with retrace lines | R3570 (0,68 r) | ||
| PHILIPS |
4CM5299
|
Image ok at 640x480 but shifts to the right at 800x600 | Replace c2505 3.3 uf by 4.7 uf. located not pine 10 of ic7502 (hef4538 mode detector) | ||
| PHILIPS |
4CM5299
|
Image too wide | Check bd677 | ||
| PHILIPS |
3CM9609
|
Dead | R3121 (270 k 1 w) | ||
| PHILIPS |
201B10
|
No horiz sync when changing resolution | C2431 (150 nf 63v) | ||
| PHILIPS |
TAPE-DECK 06AC060
|
Dead on a channel | Ts432a, ts432b, c760 e r606 |