Samsung Repair Tips
Search: samsung
Results: 3878
Results: 3878
Make | Model | Symptom | Problem | Solution | By |
---|---|---|---|---|---|
SAMSUNG |
CL29C650QG
|
Turns off and on by itself | R330 which is a 5.1v zener | Put a new one | Dj Velk |
SAMSUNG |
LN32R71BAX
|
Check dry electrolytic capacitors on main board | Tsound was no sound and the image was failing | Rmseletronica | |
SAMSUNG |
CL-21K40MQ
|
TV changing channels alone | Cause was the dz 213 zener diode with a super leak | Adalton ams | |
SAMSUNG |
CL21K40MQGXXAZ
|
Vertical closing at the top and doubling the image, tsound is no power supply on pin 6 of the vertical ci | D303 1n4007 | Replace | Mauro Mascarenha Tel. 88 981422821 Parazinho - Ceara |
SAMSUNG |
CL21Z58MQ
|
Vertical closing at the top and doubling the image, tsound is no power supply on pin 6 of the vertical ci | D303 1n4007 | Replace | Eletrônica Mauro Mascarenha tel. 88 981422821 Parazinho - Ceara |
SAMSUNG |
CL21A551
|
Vertical closing at the top and doubling the image, tsound is no power supply on pin 6 of the vestical ci | D303 1n4007 | Replace | Mauro Mascarenha Tel.(88) 981422821 Parazinho - Ceara |
SAMSUNG |
UN32FH4205
|
Totally inoperative. without any reaction. | Power supply board diode- dm807c- (lt3137) in total short. | Carlos Maia | |
SAMSUNG |
UE32D4003BW BN44-00472A
|
Does not remain on standby. Turn off with the remote control, the TV turns off and then turns on again. | Filtering on 5v and 12v lines | Replace 5 and 12v electrolytics at the power supply. cm858 and cm860 | cartened |
SAMSUNG |
PL51F4000
|
Tsound is no image, the LED is blinking | In my case c5072 102 1kv those blue ones on the ysus board in short, be very careful with them, just look carefully and you will see it with a hole or crack | Replace c5072 or those blue ones that have a hole or crack | beto2828 |
SAMSUNG |
UN49K6500AG-CURVA
|
Turns on normally.leds light up.no image.on t.with only 12v.fuse f2-3a open.measuring the power supplys for mass, avdd was found to be only 2 ohms.measuring the continuity for the screen, the last 1uf smd capacitor to the right of the shorted display flat. | Changed the capacitor and fuse TV returned to normal with image and sound. | gesuino | |
SAMSUNG |
CL21K40MQ
|
League without video with black stripe on the horizontal side, | Diode, d405 1n4148 next to the video connector | DJ PITUKA | |
SAMSUNG |
UN32FH4003GXZD
|
Tv doesn't light up standby led, power supply ok when removed power on off pin.... then you condemn main board, but it's not... | When pressing the ic 1501 next to the varicap block, it worked | Resolder using a thermal blower or, if possible, with a soldering iron and go for it... | ELETRÔNICA ZANAGA |
SAMSUNG |
UN32F5200AG
|
Dead | Rewrite eprom | CROCLARO | |
SAMSUNG |
UN32D4000NGXZD
|
It doesn't turn on, and just has the standby LED blinking. | Defect on the power supply board. | Repair of the power supply board, changing the 100x16v cm806 capacitor and placing a 100k resistor from base to ground on the qm855 transistor. | rafaelmoraes99 |
SAMSUNG |
UN32J5200AG
|
Does not turn on standby LED off | Power supply goes into protection and does not power the main PCI | After analyzing the entire power supply I discovered the dm861c had a short and when replacing the power supply and TV it worked. | janilson |
SAMSUNG |
LN32B450
|
With sound without image | Thanks to my friend roberto reparas for the tip, to put an r=4.7 k between pins 16 of the ic without 2006 when inverting the socket, thanks dear, thanks | Thanks to my friend roberto reparas for the tip, to put an r=4.7 k between pins 16 of the ic without 2006 when inverting the socket, thanks dear, thanks | |
SAMSUNG |
PL42A450P1
|
No image | Tsound was no vs voltage on the y-sus board and z-sus board, SMD capacitor (c2058) short circuited on the controller board, also blowing the fuse. | SMD capacitor (C2058) replacement or removal and fuse replacement. | Carlos Alberto (ELETRÔNICA BATURITÉ) |
SAMSUNG |
T24A550
|
Sem os 5v do stand by | Zdm801 in the power supply primary with leakage | I put a 9.1v x 1/2w zener in its place, also check zdm802 | SILNEI |
SAMSUNG |
UN-46FH5003G
|
Blinking LED does not turn on | Capacitor without capacitance | Replace cp 812 22x50v power supply | Laercio umuaramapr |
SAMSUNG |
LN26B450C4M BN44-00264A
|
Fault in the power supply primary. fuse fm802s (2a/250v) open, zener zm801 (1n4740a) with leak and ci um801s (ice3br0665j) blown | Change fuse fm802s zener zm801 and ci um801s | JJOSRJ |