Sony Repair Tips
Search: sony
Results: 20073
Results: 20073
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| SONY |
CCDFX310
|
Intermittent mosaic picture (found sync generator ic704 bad) | Camera had intermittent mosaic type picture upon power on.this would happen every 4-5 times of powering unit on and off. | ||
| SONY |
CCDF77
|
No pix from vtr, no pb rf (found open trace on ss100 board) | When camcorder is in play mode, no picture. no rf on pin 3of cn508 (pbrf testpoint). also missing was switching 5v (rec/pb) on pins11/12 of cn501 and pin 25 of ic506. also missing was 5v on pin 27 ofsame ic. found power line 5v open between l502 and | ||
| SONY |
CCDF601
|
No pix from vtr, no pb rf (found open trace on ss100 board) | When camcorder is in play mode, no picture. no rf on pin 3of cn508 (pbrf testpoint). also missing was switching 5v (rec/pb) on pins11/12 of cn501 and pin 25 of ic506. also missing was 5v on pin 27 ofsame ic. found power line 5v open between l502 and | ||
| SONY |
CCDF56
|
No pix from vtr, no pb rf (found open trace on ss100 board) | When camcorder is in play mode, no picture. no rf on pin 3of cn508 (pbrf testpoint). also missing was switching 5v (rec/pb) on pins11/12 of cn501 and pin 25 of ic506. also missing was 5v on pin 27 ofsame ic. found power line 5v open between l502 and | ||
| SONY |
CCDF55
|
No pix from vtr, no pb rf (found open trace on ss100 board) | When camcorder is in play mode, no picture. no rf on pin 3of cn508 (pbrf testpoint). also missing was switching 5v (rec/pb) on pins11/12 of cn501 and pin 25 of ic506. also missing was 5v on pin 27 ofsame ic. found power line 5v open between l502 and | ||
| SONY |
CCDF501
|
No pix from vtr, no pb rf (found open trace on ss100 board) | When camcorder is in play mode, no picture. no rf on pin 3of cn508 (pbrf testpoint). also missing was switching 5v (rec/pb) on pins11/12 of cn501 and pin 25 of ic506. also missing was 5v on pin 27 ofsame ic. found power line 5v open between l502 and | ||
| SONY |
CCDF402
|
No pix from vtr, no pb rf (found open trace on ss100 board) | When camcorder is in play mode, no picture. no rf on pin 3of cn508 (pbrf testpoint). also missing was switching 5v (rec/pb) on pins11/12 of cn501 and pin 25 of ic506. also missing was 5v on pin 27 ofsame ic. found power line 5v open between l502 and | ||
| SONY |
CCDF401
|
No pix from vtr, no pb rf (found open trace on ss100 board) | When camcorder is in play mode, no picture. no rf on pin 3of cn508 (pbrf testpoint). also missing was switching 5v (rec/pb) on pins11/12 of cn501 and pin 25 of ic506. also missing was 5v on pin 27 ofsame ic. found power line 5v open between l502 and | ||
| SONY |
CCDF301
|
No pix from vtr, no pb rf (found open trace on ss100 board) | When camcorder is in play mode, no picture. no rf on pin 3of cn508 (pbrf testpoint). also missing was switching 5v (rec/pb) on pins11/12 of cn501 and pin 25 of ic506. also missing was 5v on pin 27 ofsame ic. found power line 5v open between l502 and | ||
| SONY |
GDM20SE1
|
Vert. line in picture | Picture shows faint vert bar, 5 mm wide, 1/3 from left side.subtle effect noticeable on white raster at 640x480 and 1024x768resolution. line location on crt uneffected by moving raster side toside. one customer complained about it, the other didn't. re | ||
| SONY |
CPD17SF2
|
Faint vert. lines center & right side picture | Two faint vert. lines. looks like drive line but it is 2 from the right side. the other line is in the center but is waveshaper. we verified this with another unit that was in the westwood ssc. | ||
| SONY |
CPD17SF2
|
Unit dead | Unit dead, no lights. first check shows q507: h. outshorted. replaced q507 and unit has hv. but, unit shuts down, save andpower leds flash, size light on. fbt t501 pin 11 has about 3v, should beabout 10v. ic901 pin 18 is below 2.6v. found d596 lea | ||
| SONY |
CPD17SF2
|
Dead, ps ic failure | Monitor was dead. | ||
| SONY |
CPD17SF2
|
Das does not show hv shutdown | Unit was in high voltage shutdown. proper led was blinkingto indicate hv shutdown. das did not indicate problem. everything elsewas normal for set in hv shutdown. | ||
| SONY |
CPD-17SF2
|
No red color | Loss of red signal on the a board. intermittant red colorwhen a board is jolted. r392 is touching ic306 shield cover. | ||
| SONY |
SV676UC
|
No ctl not tracking -replaced defective x503 on ma62 board | Unit had no counter or ctl track, will not lock up. | ||
| SONY |
SLV980HF
|
Starsight data is lost after pwr failure - d205 backward | Starsight data may be lost after a power failure. | ||
| SONY |
SLV940HF
|
Won't record linear audio | Unit will not record linear audio track when using vhf input it works with line input. in tuner mode, the linear audio track records from standard output from tuner btf-wa402 p/n 8-598-254-00. | ||
| SONY |
SLV900HF
|
Won't play sp or rewind - replaced open c106 in power block | Unit came in with distorted picture, capstan motor did not go in ff or rew. | ||
| SONY |
SLV900HF
|
Won't accept tapes | Unit would not accept tapes gear mechanism damaged. found unit would load and thread but drum would not spin. no drum data pin 12 cn202. -solutoin: found drum data pin 74 of ic203, d202 was breaking down and taking |