☰

Sony Repair Tips




AIWA
BEKO
CCE
CINERAL
DAEWOO
FUNAI
GRADIENTE
GRUNDIG
HITACHI
ITT
JVC
LG
MITSUBISHI
PANASONIC
PHILCO
PHILIPS
PIONEER
RCA
SAMSUNG
SANYO
SHARP
SONY
THOMSON
TOSHIBA
VESTEL


Search: sony
Results: 20077
Make Model Symptom Problem Solution By
SONY CCDTR81
No video in playback This camera had e to e video but no playback
SONY CCDTR71
Defective switch block This camera would not stay on if the hi fi sound switch was onthe 1 position. the vtr section would shut off if the hi fi switch wasin the 2 position. everything was fine if it was in the hi fi position.
SONY CCDTR71
No power/replace c391 No power, has blown fuse.
SONY CCDTR65
Mode box connector j-14 /j-6082-197-a, j-6082-198-a Two types of connectors are used on this camera. it cannot beconnected to the mode box. i need adaptor on new extension board. -hq comments: the part number for j-14 on page 166 of the service manualis incorrect. please use part numbers j-6082-197-a a
SONY CCDTR65
Shaded evf picture with mpk-tra When using the ccd-tr65 with a mpk-tra, a gap between theeyecup of the evf of the camera and the rear protector of the marine packmay cause shading on the evf picture. -hq comments: replace the eyecup of the evf with the spk lens assy(x-3943-699-1). to
SONY CCDTR61
Mode box connector j-14 /j-6082-197-a, j-6082-198-a Two types of connectors are used on this camera. it cannot beconnected to the mode box. i need adaptor on new extension board. -hq comments: the part number for j-14 on page 166 of the service manualis incorrect. please use part numbers j-6082-197-a a
SONY CCDTR6
No pix/no zoom/no focus/clean around cn304 No picture, zoom or auto focus operation. manually openingiris gives good picture. iris adj and focus ref lines from ic611 werelow. clock signal to ic611 appeared as if data was mixed in. signal wasreduced to less than 1 volt across r663. measured a
SONY CCDTR51
No camera "e to e" video/resolder cn801 Iris is open but there is no camera video.
SONY CCDTR500
Dropouts/replace rail base x-3941-929-1 This unit showed subtle but constant glitches and smalldropouts when playing back recorded material. it also had intermittentnoise (mechanical) during rewind.
SONY CCDTR101
Pix shakes intermittently/replace s reel x-3727-952-1 Pix shakes intermittently. by observing the tension arm, inoticed that it also vibrated occasionally. found sticky/worn-out s reel.
SONY CCDTR101
No camera video "e to e"/replace core ic708 No camera video e to e.
SONY CCDSC5
No audio/replace ic202 Not audio.
SONY CCDSC5
Lcd dead/resolder l106, pd42 Lcd was blank, however, on screen data was barely visible dueto ambient light.
SONY CCDFX710
Horizontal distortion in camera video/replace x801 An inch thick horizontal noise bar on screen. camera e to evideo.
SONY CCDFX710
Unit cuts out when superimpose memory button pressed/ic506 When depressing memory button for superimpose function, the entire unit cuts out for a brief period of approx. 2 seconds.
SONY CCDFX620
Distorted pix in playback/replace head amp ic001 Picture was distorted in playback with self recordings.pre-recorded tapes played back fine. found problem to be no atf signalbeing recorded onto the tape. atf record signal was at pin 18 of ic501but extremely low at pin 46 of ic001 the head amp. the d
SONY CCDFX310
Unit thinks there is a tape in it/resolder ic501 Unit cycles as if there was a tape in it.
SONY CCDF70
Viewfinder exhibits moire pattern The viewfinder exhibited what resembled a moire pattern in the upper third of the viewfinder. its shape and size responded to adjustment of the afc control.
SONY CCDF620
Part number needed Need the correct part number for v-901. there are two typesused in this model. vf-44 and vf-51. the crt type for vf-44 is m01kqm07wb. the crt type for vf-51 is m01kta8wb.part number 1-546-091-11 appears to the crt for the vf-5 - type b. -hq commen
SONY CCDF56
No camera video/resolder ic656 Unit had no video out. there were two boxes in vf and afwould go to one end of focus. burst level was very low.