Sony Repair Tips
Search: sony
Results: 20077
Results: 20077
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| SONY |
CDXA55
|
Missing part # for fusable link (order p/n 1-532-686-21) | No part ref. # or part # listed in manual or supplements foric901 fusable link. this link is not shown on the schematic or partsmounting diagram. it is found on the jack board, and is marked n75j. donot confuse this ic901 with the voltage regulator ic9 | ||
| SONY |
STRAV550
|
Protection light on - ic701, r707 faulty | Fuseable resister r707 (100Ω) over-dissipated in thepower board. ic701 defective. ic701 had -41vdc at pin 12 causing on theoutputs. | ||
| SONY |
KV27V55
|
No color, repaired solder connection q3206 (base) (p board) | No color. | ||
| SONY |
KV27TS32
|
Squeal, added glue to jw505 | Unit would squeal, found jumper jw505 on the d board was thecause of the squell. | ||
| SONY |
CPD1304
|
Dead /continually blows q-401 (b+ regulator) | |||
| SONY |
RME700
|
Compatibility of the cvd1000 and rme700 edit controller | |||
| SONY |
CVD1000
|
Compatibility of the cvd1000 and rme700 edit controller | |||
| SONY |
SPP180
|
Test program procedures | Following the base phone procedure on putting the base in testdoes not seem to work. after depressing the numbers on the keypad, noneof the rest will respond. | ||
| SONY |
KV27FX10
|
Dead sleep light on, replaced ic601 (g board) | No power, only sleep light on. | ||
| SONY |
EVS3000
|
Color noise after 30 minutes, x701/di-46 bd | In pc unit develops color noise after 30 minutes only with tbcon. turn tbc off or change dnr setting which turns tbc on and noise isonly present with tbc on. | ||
| SONY |
SLV900HF
|
Remote control cannot memorise zenith codes: see page 12 sm | We have a dealer that reports a problem with the programmablefeature on the rmtv129. it will not operate correctly with a zenith tvmodel: sj276555, serial: 19223372409. servicer has also tried anotherzenith with no success. do you have any suggestions | ||
| SONY |
KV27XBR35
|
High voltage shut down, replaced q506 (a board) | The unit would immediately go into high voltage shut down.the problem was caused by a shorted pin output fet. (short d-s) the setwas developing maximum high voltage for the applied b+ of 135v. | ||
| SONY |
KV32XBR95
|
Excessive width, replaced q506 ("a" board) | The unit had excessive width and the pincushion was poor. theproblem was caused by a leaky pin output fet which was permitting to muchcurrent to flow in the horizontal output. this of course increased thewidth and high voltage. interestingly, the unit | ||
| SONY |
STJX520
|
No fm reception - d502, c506 faulty 8-719-200-02 | No fm reception noise when unit is turned on. r507 outputonly 11v dc (should be 42v). defective d502 and c506 caused voltage todrop down from 42v to 14v dc. | ||
| SONY |
SV575UC
|
No power, replaced ic101 | No power after lighting storm. | ||
| SONY |
SLV575UC
|
Power supply part list missing from sm, see supplement-2. | No power supply part list in the service manual. -hq comments: see the service manual supplement number 2, part number9-972-907-82. | ||
| SONY |
CFD58
|
Intermittent or no fwd play | Ref#175 gear (base), head becomes bent, therefore, ref#172spring (head) torsion does not complete its cycle. also, ref#152 gear(nr) cam has insufficient motion to complete its cycle. | ||
| SONY |
GDM2038
|
Difficulty adjusting the white balance | |||
| SONY |
CPD1730
|
Difficulty adjusting the white balance | |||
| SONY |
CPD1430
|
Difficulty adjusting the white balance |