Sony Repair Tips
Search: sony
Results: 20072
Results: 20072
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| PHILIPS,CCE,SONY |
VALIDO PARA AS MESMAS
|
TVs turn off so quickly that we have no idea wsound to look for the defect, sound are some tips. You will use 3 diodes in4148, connect the anodes to the connector that comes from the main board to the tube board pin1,2,3 and join the cathodes and connect to pin 5, ready, the TV will no longer turn off, you will see the corresponding defect on the screen. This applies to the brands: Philips, CCE, Sony. In the case of Sony, we use 1k by 1/4W resistors, we connect each one to the RGB resistors We join the 3 ends and solder them to the connection, cool, in case the TV turns off so quickly that we have no idea, as already explained wsound the defect is, this tactic will release the plot faster on the screen, generally it takes 10s to release it, we reduce it to 4s You will use an 800m 6+6 transformer, connect it to the filament, wait for the cathodes to heat up and turn on the TV. Tsound will be a way for you to access the error code and view the plot. Tsound is a way for you to view the corresponding defect on the screen or how to access the error code. ex:0 0 0 0 0 how is 0 0 0 0 0 it means that the TV is working correctly if a number appears it is a sign that the TV is defective in another stage, the error code counts from left to right ex: 9 0 0 0 0 this 9 points to the eeprom memory or it is defective or lost or even a lack of power. a 10k resistor in the case of sdam1 sdam2 connect a short circuit from one to the other and turn on the TV when it starts remove the short immediately the TV will turn on in service mode this is either without the TV's CR or the TV is not turning on alone The LED turns on and the LED indicates the error code, eg: 9 blinks correspond to an error. | Miltom eletronica micro e epron | ||
| SONY |
KV29FS110
|
Tries to start and comes back to stand by flashing | Q512 and d 500 short | Replace the same | haecio |
| SONY |
KV-1440
|
Turns on with audio without image dark screen | Res 507=220k | jacsson | |
| SONY |
KV-32FD1E
|
After 15 seconds it turned off and flashed 4 times | Circuit ic stv9379 failed | Replace stv 9379 vertical circuit | antonio costa |
| SONY |
KV-29FS140
BX1L |
It does not turn on, the opto, ic regulator of the supply, 36v zener was changed. According to the diagram, the two capacitors, I already get voltage in the secondary, in the +b it outputs 50v. The 3.3 plus 1.8 appears but the 12v does not appear. What I have noticed is that tsound is a voltage fluctuation between 11v-15v in the primary, if you could help me I would appreciate it. | The power IC was found, a 1k resistor, the opt, and a burnt zener. | ||
| SONY |
MHC-RG444S
|
No sound, no Audio, stk 403-130 ok. | Open 100r resistor r496 on the stk pci. | I just added another one and the sound returned to normal. | |
| SONY |
HCD-RG55
|
Reset | Press on the panel between stop and power | beto2828 | |
| SONY |
KV32FQ85E
AE6BADY |
Led flashes 16 times | Vertical seen on the oscilloscope ok, matte wouldn't start, tsound were all tensions. | Ic 6802, mcz3001d off, it is on the line transformer board | Corvo |
| SONY |
KV32FQ85E
AQE6BADY |
Led flashes 16 times | Vertical seen on the oscilloscope ok, matte wouldn't start, tsound were all tensions. | Ic 6802, mcz3001d off, it is on the line transformer board | Corvo |
| SONY |
DVP-NS57P
DVD |
Sometimes it works and sometimes it doesn't, apparently normal power supply | Diode d315 with problem, can be replaced with 1n4148 | fabiusmax | |
| SONY |
FH-B7CD
|
Weak or unlit display | Review power supply -24v or diode d 910 = 24v shorted | ramiresrc | |
| SONY |
KV-29XXAE1C
AE1C |
Noise, intermittent, intense in the transformer lines, as if it were a leak. the image closes - horizontal and vertical | 500khz ceramic crystal, next to the defective tea2028, although apparently it is oscillating correctly. Please note that it has to be exactly the same - b500 - the remote controls are oscillating a little out of frequency | Replace ceramic crystal | extremos |
| SONY |
KV-1450B
|
Does not release the video and +b voltage is high | 330k resistor that is in parallel with the 180v RGB power supply capacitor, the power supply increases with the lack of this resistor and the TV does not release brightness | simas433 | |
| SONY |
KV-29T76
|
It turns on for 3 seconds and turns off as soon as the video appears | R-675 470k (it is close to the flyback) | simas433 | |
| SONY |
SLV-D550P
|
It doesn't play the disc, when I put the disc in it reads, then play appears on the screen and the motor stops working, the VHS works normally. | The client indicates that by mistake he placed the plug at 220v and it no longer turned on. After checking, I found the blown fuse, changed the fuse and that's it. | ||
| SONY |
MC
|
It takes a while to turn on and only the tuner works but it doesn't lock any radio station and when I try to change the CD it doesn't respond the key is always in tuner | Micro contrador | JOSE LUIS AMBROSIO | |
| SONY |
GRX 9900
|
Alarme power protection | Ic 801 stk 411-550e sending dc at the output | Replace stk 411-550e | Jaison |
| SONY |
SCPH-75007
|
No image, everything works but tsound is no video | Check the diode, which is on the bottom of the main board, on the right side, next to wsound it says (sony computer entertainment. | Diode replacement (it was shorted) | johnny busnadiego |
| SONY |
KV-29T76
|
Turns on with black stripe on the right side of the tube and then turns off | Cold solders on fly and ic 601 | MB ELETRONICA | |
| SONY |
MHC-DX3
|
No audio | Ic102 and 104 shorted or altered | Replace | paulo-maceio/al |