Sony Repair Tips
Search: sony
Results: 20100
Results: 20100
Make | Model | Symptom | Problem | Solution | By |
---|---|---|---|---|---|
SONY |
KV-1450B
|
Does not release the video and +b voltage is high | 330k resistor that is in parallel with the 180v RGB power supply capacitor, the power supply increases with the lack of this resistor and the TV does not release brightness | simas433 | |
SONY |
KV-29T76
|
It turns on for 3 seconds and turns off as soon as the video appears | R-675 470k (it is close to the flyback) | simas433 | |
SONY |
SLV-D550P
|
It doesn't play the disc, when I put the disc in it reads, then play appears on the screen and the motor stops working, the VHS works normally. | The client indicates that by mistake he placed the plug at 220v and it no longer turned on. After checking, I found the blown fuse, changed the fuse and that's it. | ||
SONY |
MC
|
It takes a while to turn on and only the tuner works but it doesn't lock any radio station and when I try to change the CD it doesn't respond the key is always in tuner | Micro contrador | JOSE LUIS AMBROSIO | |
SONY |
GRX 9900
|
Alarme power protection | Ic 801 stk 411-550e sending dc at the output | Replace stk 411-550e | Jaison |
SONY |
SCPH-75007
|
No image, everything works but tsound is no video | Check the diode, which is on the bottom of the main board, on the right side, next to wsound it says (sony computer entertainment. | Diode replacement (it was shorted) | johnny busnadiego |
SONY |
KV-29T76
|
Turns on with black stripe on the right side of the tube and then turns off | Cold solders on fly and ic 601 | MB ELETRONICA | |
SONY |
MHC-DX3
|
No audio | Ic102 and 104 shorted or altered | Replace | paulo-maceio/al |
SONY |
29T75\T80
|
Activating protection when switching on | Vertical output damaged tda8172 shorted, c541 open | Check the items above first, because the first impression already condemns the poor flay-back. | luizsharp2 |
SONY |
DVP-NS50P
|
The dvd doesn't turn on | No voltage of sw=8v; sw=3.5v;sw=5v | Matheus | |
SONY |
KV25T2E
FE1 |
Does not turn on and blinks 2 times on the s/by LED | The 135v line is at 0 and has a mass passage of 214 omes | Capacitor c 607 102k 2kv with leakage and is next to the corresponding diode | Antonio Fernandes |
MINI SYSTEM SONY |
MHC-RG 22
* |
Prompting the following message posh power protect. | C-509 r511 if the output is not faulty it will come out and sound normal | Your replace | wagner |
SONY |
KV 200MG
|
When turned on, 03 lines appear (green, red and blue), then the image appears with the vertical semi-closed at the top. | Saida vertical (the 7830). | FERNANDO S | |
SONY |
KV TODAS
|
Low sound | Defect in selectornic | Breaking trick, remove the internal capacitor from the audio decoil t 02 and place a 4.5mb crystal in place of the removed capacitor and adjust it if necessary; Importantly, this crystal comes with 3 terminals, you have to cut the first terminal, and just run for a hug, tsound is no other way to repair the defect | fernandoferreira |
SONY |
KV-2170B
|
+b com 200v | This device arrived in my hands with the converters q602 and 603 (2sc 4034e) and the zener diode d613 (r2m) shorted. After exchanging these components and without observing any other components with apparent problems, I turned on the device and the r2m diode shorted again. Removing it from the circuit I verified that the +b voltage reached 200v, when normal is 125v. After several hours of measurements I verified that the resistor r618 (100k x 1/8w) was open. went to change and run for the hug. | Paulorusso | |
SONY |
KV-X2131D
|
I'm sound | In addition to tr q251 and q261 of the mute circuit tsound was a 560k resistance (r256) open | masfe | |
SONY |
KV200MG
|
I'm sound | For no apparent reason | Release jump 110 (mute system) | Tectoy |
SONY |
29-XTR30
|
Jagged image | C815 | Replace component | CSOM-(066)34231060 |
SONY |
29-XTR30
|
Jagged image | 9 and 12v power supply | Check the filter capacitors of these lines | CSOM-34231060 |
SONY |
TA 3650
|
Doesn't work | Fixed | Device working | cesar |