Sony Repair Tips
Search: sony
Results: 20088
Results: 20088
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| SONY |
KV36XBR800
DA4 |
Purity failure, stained screen in the 220v area | This procedure must be carried out following technical bulletin 05/03 only when stains persist on the TV screen, in 220v areas | technical bulletin 06/03 sony kv-36xbr800 | ITAN |
| SONY |
KV36XBR800
DA4 |
Fails purity | This procedure applies to correcting the actuation time of the demagnetizing coil, when the device is connected to the 220v network, avoiding the appearance of spots on the screen. | technical bulletin 05/03 sony kv-36xbr800 | ITAN |
| SONY |
KV34FV15B, KV38FV15B
|
Non-uniform brightness. left side of the screen is darker | Remove l504 and resolder it on the copper plated part, change the dynamic focus compensation circuit, see technical bulletin. | technical bulletin sony kv-34fv15b | ITAN |
| SONY |
KV29XTR20
|
Does not tune channels | Inductor terminal l101 (varicap power supply) is broken in the solder. | Resolder the terminal and rework the plastic support | ITAN |
| SONY |
KV29V55. KV34V55
|
High voltage leakage and consequent carbonization of the printed circuit track | <a target="_blank" href="http://www.electronica-pt.com/boletins/boletim99999.pdf">technical bulletin sony kv-29v55</a> | High voltage circuit replace | ITAN |
| SONY |
KV29T75. KV29T80
|
Tinnitus | <a target="_blank" href="http://www.electronica-pt.com/boletins/boletim-3599.pdf">sony technical bulletin</a> | ITAN | |
| SONY |
KV29FV15B
AA2W |
Distorted image at the top of the screen. | <a target="_blank" href="http://www.electronica-pt.com/boletins/distorcao-imagem aa-2w.pdf"><img src="images/moreinfo.png" alt="aa-2w info" /></a> | ITAN | |
| SONY |
KV29FS100
BA5D |
Flickering or distorted image at the top of the screen | <a target="_blank" href="http://www.electronica-pt.com/boletins/chassis ba-5d 0203 distortion.pdf ">technical bulletin sony ba5d</a> | ITAN | |
| SONY |
KV34FV250
BA5D |
Buzzing (hum) in audio at low volume | <a target="_blank" href="http://www.electronica-pt.com/boletins/boletim tecnico 34fv 1402.pdf">technical bulletin</a> | ITAN | |
| SONY |
KV29FS100
BA5D |
C board ic702 dead | <a target="_blank" href="http://www.electronica-pt.com/boletins/ba-5d 1502 pci c.pdf">technical bulletin</a> | ITAN | |
| SONY |
KV-29T76
|
Connects with return lines and fires | R 590 100k changed | reginaldo | |
| SONY |
KV-32S20
AA2 |
Dead set | Faund [q601] and [ q602 ] and hout,shorted,[ c4834 ] replace all, and tried to stard. | Thomas Acoreano | |
| SONY |
KV29T76
|
Doesn't start | I tested it and didn't find anything burnt, so I tested it at 220v, it worked, I replaced the ic603 str81159 and that's it, it worked at 110v | Sidney Alves | |
| SONY |
MHC-RG290
|
Shows eject on the display and then turns off and the device does not work | The photo sensor on the tape is open, causing the claimed defect. This happens because the device's taps need to be synchronized. | Replace the photo sensor | celinvds |
| SONY |
KV2158
|
Inoperative, relay knocking, +b oscillating | Vdr601 varistor overheating and leaking | Manoel | |
| SONY |
KV 140MG
|
Dark screen, with sound | Lack of filtering on the +b 200v. | Capacitor 10/250v | claudioaudioevideo |
| SONY |
BE4A
BE4A |
The device turned on and off. but it generates high voltage. The LED flashes 6 times | Ic vertical- tda9302 | Replace and one less that stopped bothering me. | Antonio Correia |
| SONY |
KV-14M1E
BE4A |
The device turned on and off. but it generates high voltage. The LED flashes 6 times | Ic vertical- tda9302 | Replace and one less that stopped bothering me. | Antonio Correia |
| SONY |
KV-2162S
CA-1 |
Characters the volume goes to maximum but the sound remains low | Channel selector (varicap) | Unfortunately tsound is no solution, as this varicap is no longer available. | Center Som |
| SONY |
KV2162-2163-2158
KV |
Contosh-short-start power supply c 4833 | Cap. c624 2,2 450v | C4833 also works but 11a/f this one I learned from jaja he is great | magroboy |