Sony Repair Tips
Search: sony
Results: 20088
Results: 20088
Make | Model | Symptom | Problem | Solution | By |
---|---|---|---|---|---|
SONY |
KV 205 MP
|
No sound in rf note: sound has sound in av | Replace ic 402 | valdemiro
|
|
SONY |
KV 32 FQ86E
|
LED blinks 16 times and does not start TV | Replaces the mcz3001d and electrolytic capacitors on the periphery | It was ok | fhmc |
SONY |
KV-2970
|
Burning the +b 150v zener. | Oscillation on the t603 pin (6;7) | edson melo | |
SONY |
KV-21
BE-5 |
LED flashes constantly and tsound is no high | Sda 5255 burnt, replace | Gaspar Aedo | |
TV SONY |
KV 2970 T
|
Interference on channels in normal rf av | Changed c 102 22 micr 25 volts | jaironuness | |
SONY |
KV-200MG
|
Power supply transistors burned, changing them, high and horizontal power supply stretched | R618 changed | Ronie Grein | |
SONY |
MHC-RG77
SOM DE TRES CDS |
When turned on, the sound went into protection mode and turned off. The message appeared on the screen like this (protect power) | I checked the power supply but everything was fine, then I removed the number sound output (stk412-150). But then the unlikely thing happened, the sound only comes on on the panel with the output in place. Then I counted on luck and malice. I turned on the sound and left it in protection mode with the outlet in place. That's when I put my hand on the outlet and it was quite hot. | I replaced the output and tsound was a file | |
SONY |
PLAYSTATION 75001
SPCH |
No image appears when turning on the device | Unlock burnt | Check the unlock or power supply voltage next to the unlock that connects the 3 volts | Elias |
SONY |
KV-29T80
|
Open the image then turn it off | R575 470k open | MB | |
SONY |
KV2553MT
GP1 |
Horizontal line in the middle of the upper limit | C558 (560uf/25v) | Replace c558 with a 680μF/50v 105º | joaquim cunha |
SONY |
KV2553MT
GP1 |
Ow of, no adjustments | C830 e c831 (1uf/25v), ic tde-a2031a | joaquim cunha | |
SONY |
KV2553MT
GP1 |
Trc very bright and no image | C852 (22/250v),r851 (0.47r),d851 | joaquim cunha | |
SONY |
SCPH9001
PLAY |
Controls don't work | Ps605 1.5 amp smd fuse open | Replace fuse, controls work normally again | |
SONY |
KV-2170S
|
It tries to oscillate horizontally but it doesn't turn on. power supply oscillates normally has 115 volts tv makes a noise and doesn't work | Does arming protection is consuming | Replace o flyback at 2078 u0 (philips) | Amauri |
SONY |
KV3459T
|
Power supply drops less than 80v. | Q605 leaking | Q605 replace | |
SONY |
KV29T75
|
Turns on and falls into protection | Ic 601,c634 | LED flashes 2 times with time | ffeet |
SONY |
DAV DZ820KW
|
I'm sound | D931 shorted +b 31v | BRUSKE | |
SONY |
2970T
AA1 |
Device does not turn on, protection working | Horizontal drive(q502) with cold welding | Resolder the same | sqpester |
SONY |
HCD-RRG66T
|
No sound comes out and no protection is activated, the sound output does not heat up, everything is normal (c551 and c554 overheated) audio output is open | Change the audio output and the two capacitors c551 and c554. | ||
SONY |
HCD-RRG66T
|
No sound comes out and no protection is activated, the sound output does not heat up, everything is normal (c551 and c554 overheated) audio output is open | Change the audio output and the two capacitors c551 and c554. |