Sony Repair Tips
Search: sony
Results: 20100
Results: 20100
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| SONY |
SLV575UC
|
Intermittent play and eject | Cam motor and loading motor would only drive in one direction. | ||
| SONY |
KV27XBR15
|
Part number for cable from a82-c82, 1-508-768-00 | Is the 6 pin cable between the a-82 connector and the c-82connector available and if so, what is the part number? -hq comments: please see pg 92 of your service manual under c-board(connectors). you will see c82, p/n 1-508-768-00, connector (5mm pitch) | ||
| SONY |
CDPX77ES
|
Drawer opens but won't close when open/close button pushed | When the unit is turned on, the drawer would open but will notclose when the open/close button is pushed. | ||
| SONY |
SLHFT7
|
Distorted picture | Picture jumps, won't lock with tracking, no rf switching pulsefrom (ic-001 pin 34 servo). | ||
| SONY |
SLV70HF
|
Counter stops intermittently | Counter would stop reading and all other functions ok. ctlpulse was not a problem. | ||
| SONY |
SLV575UC
|
No rewind | Unit has no rewind. | ||
| SONY |
ICFSW7600
|
No audio in shortwave mode | No audio in shortwave bands - other bands ok. | ||
| SONY |
SLV676UC
|
No video output | No video out in tuner ee mode. all other inputs ok. tapeplays fine. | ||
| SONY |
CCDF33
|
No power | No power at all. all functions do not work. ic-501 gets ever5v (vpp and vss) but does not turn on dc to dc. found x-501 with nooscillation. | ||
| SONY |
KV20EXR10
|
Intermittent power only, resolder hdt | Resolder cold solder connection on t-501 hdt. also foundic-301 defective. the crt was also shorted. | ||
| SONY |
STRAV1020
|
No sound out except in dolby mode | The unit would only pass sound out in dolby mode. found thatq-327 collector was not switching even though its base was. original partwas a 2sc3400 the parts list listed a dtc124es for q-327. put in newtransistor did not help. then replaced q-328, ic- | ||
| SONY |
SLV373UC
|
Rainbow pattern, ep, after 10 seconds | When playing back a self-recorded ep tape, a rainbow effectwould become noticeable after about 10 seconds. | ||
| SONY |
SLV575UC
|
Adjustment of clock accuracy | When cv-201 must be replaced, the adjustment procedure in theservice manual cannot be done because we currently do not have the equip-ment necessary. however, if cv-201 is left unadjusted the clock will betoo far off tolarance (see frp m0322 for a simil | ||
| SONY |
SLV575UC
|
Clock will not advance | When the clock is set, it will not advance, remaining at what-ever time it was set. | ||
| SONY |
KPR46CX50
|
No remote functions or demo pip, replaced c-1005 | Remote didn't work and demo button didn't work. however, youcould change channels and volume at tv. | ||
| SONY |
SLV676UC
|
Unit displays channel and then a blue screen | Whenever a channel was accessed, the unit would display thechannel and then a blue screen constantly. the channel never remained ex-cept for a very short time. this oscillation never stopped. to be morespecific, the channel and blue screen displays oc | ||
| SONY |
SPP170
|
Battery save and volume control knobs | Battery save and volume control knobs fall off the switch steminto the bottom of the handset. | ||
| SONY |
TAU10
|
No answer to ring signal | Unit will not answer to a ring signal. | ||
| SONY |
TAU10
|
Ogm, rec, p.m. buttons jamming (s-201, 2, 4) | When the ogm, rec or private message buttons are pushed toohard, they lock into the pushed position causing various problems. mainlya dead unit. this problem has occured in many of the units i have seen. | ||
| SONY |
XR5500
|
Radio section inoperative after ejecting cassette | The above symptom may occur due to a slight misadjustment ofthe small tab on the eject cam lock assy. after ejecting a tape, themisadjustment of the tab allows the carriage assy to drop back down intothe tape-loaded position, which turns on s901 (tape d |