Sony Repair Tips
Search: sony
Results: 20100
Results: 20100
Make | Model | Symptom | Problem | Solution | By |
---|---|---|---|---|---|
SONY |
CDXR77
|
Cd only plays when unit is turned upside down | Cd only plays when unit is turned upside down. | ||
SONY |
STRAV1020
|
Silkscreen for ic-251 printed on board wrong | Silkscreen printed on video board for ic-251 on video board isbackwards (ie. 180 degrees). pin 1 on ic actually corresponds to pin 9on the board. | ||
SONY |
PSLX520
|
Intermittent speed | After refering to sdis, and noting a similar problem with thiscircuit i checked r-107 and r-106. r-106 was a 390k resistor r-107 was a1.6k resistor. | ||
SONY |
SLV757
|
Does not respond to controls | Won't eject, power down. | ||
SONY |
STRAV1020
|
Protection circuit activated | Protection flashes on front display. q-719 (relay drive)shuts off de-energizing ry-701. thus opening the signal path to speakers. | ||
SONY |
CFDD73
|
Intermittent skipping / track jumping | Unit would intermittently skip and sometimes would not ams.upon monitoring sled motor drive voltage, found it to be increasing.normally, it is about 0.7v. | ||
SONY |
CFD455
|
Intermittent skipping / track jumping | Unit would intermittently skip and sometimes would not ams.upon monitoring sled motor drive voltage, found it to be increasing.normally, it is about 0.7v. | ||
SONY |
CFD454
|
Intermittent skipping / track jumping | Unit would intermittently skip and sometimes would not ams.upon monitoring sled motor drive voltage, found it to be increasing.normally, it is about 0.7v. | ||
SONY |
XR6180
|
Tape deck will not function or will function incorrectly | Have seen several units so far where both q-405 and the amsplunger were defective. the plunger was actually melted. i am unsurewhether the plunger or the drive transistor originally caused theproblem. | ||
SONY |
SLHFT7
|
Popping in beta hifi | Popping sound in beta hifi. | ||
SONY |
SLHF1000
|
No beta hi-fi record | No beta hi-fi record. playback or pre-recorded material ok.all voltages ok on ic-004. missing switching voltages at pin 44 ic-003.found open foil between q-610 and d-606. simulated shorted transistor. | ||
SONY |
KPR46DX10
|
Snowy picture on main screen when in aux, customers fault | Customer was complaining that when they hit aux they only hadpicture on the child screen, with snow on the parent screen. -hq comments: found that they were using a vcr, and cable box in linewith the converter and aux. terminals. with the vcr connecte | ||
SONY |
DTC75ES
|
Test tape ty7252 | Recommended test equipment list for dat specifies a ty7251test tape for tracking. dtc-75es manual calls for a ty7252. are theyinterchangeable? -hq comments: i will have to check with tokyo. i suspect that there isa typo in the dtc-75es service manual | ||
SONY |
SPP320
|
Intermittent ringing | The handset would only ring sometimes. in addition, thehandset would intermittently not beep when keys were pressed. flexing thehandset main pcb would cause the ringer to function. | ||
SONY |
CCDF70
|
Incorrect slow motion operation | Slow motion operation erratic. | ||
SONY |
KV2726R
|
Set in sleep mode at turn-on, replace ic-101 controller | When set was turned on, it was in the sleep mode per non-authorized servicer. after several checks, found pin 15 of ic-102(memory) to read zero volts. isolated pin 15 and 5 volts would appear onthe 5 volt line. all other readings were good. with pin | ||
SONY |
FD2A
|
Picture looks out of focus, replaced c555 | Picture appears as raster only, out of focus. in reality, thesweep is displaced far above the top of the tube due to dc level upsetcaused by shorted c-555. | ||
SONY |
FD10A
|
No horizontal sync, replaced c506 | No horizontal sync. ov at pins 17 and 18 of ic-501 causingphase detector inoperation due to shorted c-506 (pin 15, also 0 volts). | ||
SONY |
TAM50
|
Unit dead, does not respond to any button - all lights off | Unit is dead. does not respond to any button. none of thelights turn on and no beep is heard.the micro ic-3 had all the right voltages, except for ic-3/pin 8 which waslow instead of high. found that the time stamp ic-10 had no supplyvoltage. | ||
SONY |
CCDTR5
|
Dew and rec (vtr) light stays on, camera video flickers | Dew light and vtr rec light stays on and camera videoflickers. dew and vtr rec light do not affect vtr functions. |