Sony Repair Tips
Search: sony
Results: 20073
Results: 20073
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| SONY |
RMX2
|
Power harness schematic is wrong | Page 8 of the s/m shows cn-801 as a 9 pin connector, but theharness is shown as only having 4 wires. page 10 of the service manualshows all nine pins being used. the installation manual shows actualcolor code which is correct. -hq comments: the instal | ||
| SONY |
CCDV5000
|
No eject/tape jam | Tape jam and no eject. | ||
| SONY |
MPKF40
|
Models compatible with the mpk-f40 | Which models will fit in the mpk-f40? | ||
| SONY |
MPKV11
|
Modifications for use with ccd-v99 | Some mpk-v11s do not accommodate the ccd-v99. | ||
| SONY |
GVM2000
|
Support bracket part number (a board) | Support bracket for the a board on the gvm-2000 is needed.no part number is listed for this item in the service manual. -hq comments: the part number for this item is 4-393-914-02. pleaseupdate your service manual. | ||
| SONY |
KV27XBR50
|
Part number for power switch is wrong, 1-571-532-21 | Part number for the power switch is incorrect in servicemanual. -hq comments: the correct part number is 1-571-532-21. please make theappropriate corrections to your manual. | ||
| SONY |
SL2700
|
Part number for cassette in switches | On page 169 of the service manual, there is no partnumber for the cassette in micro switches (next to items 370 and 371). | ||
| SONY |
SPPS10
|
No handshake between base and handset | Intermittent no handshaking between handset and base. when acadaptor input is shaken, sometimes unit works. | ||
| SONY |
CCDF55
|
E - shutter does not change speed in manual mode | Shutter speed is fixed at 1/60 or 1/100 second, and cannot be changed with the shutter select button. | ||
| SONY |
CCDV5000
|
Part number for connector cn604 - cn301 | We need the part number for the following connector. -to tokyo: can you give us the part number for the board connectorthat goes between the di-21 board cn-604 and the vc-55 board cn-301?it is a four-pin 1.5mm pitch. thank you in advance. -hq comments | ||
| SONY |
CCDTR5
|
Caution light flashes when tape ends in play,ff of rew modes | In vtr mode when the tape ends in play, fast forward or rewind modes, the caution light flashes. | ||
| SONY |
WMAF54
|
Weak or defective tuning knobs | The tuning knob is very weak, and breaks easily or falls off. | ||
| SONY |
KV2792R
|
-33v line incorrectly labeled | The schematic shows a -33v scan derived supply from pin 7 ofthe flyback. servicer claims actual voltage is closer to 100. double-checking supply to ic-102, pins 6 and 7, verifies that voltage at thosepoints is correct. also, set is operating normally. | ||
| SONY |
CCDM8U
|
Drum speed fluctuates | Drum speed varied constantly. picture looks like it isbreathing. | ||
| SONY |
KPR46CX10
|
Part number for complete (h) board, not available | We need a part number for the complete h board on theseunits. it is very difficult to remove this board when pulling thechassis. the servicer could have this as a piece of test gear at the shopand would not need to pull this in the customer's home. th | ||
| SONY |
KV32XBR50
|
Power switch p/n not listed, 1-571-532-21 | The push button has too much travel distance and will causethe power switch to be pushed back. this will cause the back of theswitch to be pushed out. the part number for the switch is not yet listedon the system. please provide me with a switch so we | ||
| SONY |
KV13TR24
|
Inntermittent audio, speaker connection loose | Unit would intermittently lose audio. found speaker plug was not properly seated. | ||
| SONY |
KV13TR20
|
Intermittent audio, intermittent connection on "a" board | This unit had intermittent audio. found i-n wires having intermittent connection on a board. | ||
| SONY |
WMAF50
|
Intermittent distortion in left channel | When tape is playing, if the headphone jack is moved around,there will be an intermittent loud distortion in the left channel. | ||
| SONY |
CDP390
|
Ic-102 failing | Ic-102 fails and the unit will skip badly or will not play atall. the symptoms vary because the ic gets very hot and it may producemore problems. |