Sony Repair Tips
Search: sony
Results: 20073
Results: 20073
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| SONY |
CFSW370
|
Missing part number for spring | Part number missing for wishbone shaped spring on deck(center between spindles). | ||
| SONY |
SRS150
|
Audio | Complaint was no bass in speaker. i changed speaker, thisdid not help. the audio sounded clean but was lacking bass response. inoticed the audio was lower on the input of ic-201 in comparison toic-101. i traced low audio back to voltage amp q-203, al | ||
| SONY |
CFSW350
|
Removal of main pc board | Removal of main pc board from cage. caution: the pc board is held by four plastic clips on the rear case. clips are located by the speaker terminals and power plug. these clips are easy to break. | ||
| SONY |
FD230
|
Will not power on or tune in channel, see sb50 | Unit tuning point which should be at 32v is shorted to groundand burns out dc/dc conv. (ref. no. ic-602 on the a board part number,a-3015-759-a) and 6 volt regulator (q-601 part number, 8-729-101-07) whichis on the same board. received three replacemen | ||
| SONY |
CCDF55
|
Intermittent audio when using acv-60 | Intermittent playback audio when using the acv-60. movingthe cable next to the adaptor that connects to the camera increasedintermittency. | ||
| SONY |
CDXA30
|
Balance ring for cd cause it to jam while loading disc. | Disc will jam if owner has affixed adhesive balance ringaround it's circumference. -hq comments: the balance ring on the outside edge of the disc causeit to catch on the roller, as it's thickness is increased. it can alsoprevent it's slipping onto the | ||
| SONY |
CDXA20
|
Balance ring for cd cause it to jam while loading disc | Disc will jam if owner has afixed adhesive balance ringaround it's circumference. -hq comments: the balance ring on the outside edge of the disc cause itto catch on the roller, as it's thickness is increased. it can alsoprevent it's slipping onto the t | ||
| SONY |
CDXA10
|
Balance rings for cd's cause cd to jam while loading disc | Disc will jam if owner has afixed adhesive balance ring aroundit's circumference. -hq comments: the balance ring on the outside edge of the disc cause itto catch on the roller, as it's thickness is increased. it can alsoprevent it's slipping onto the t | ||
| SONY |
CCDF33
|
Part no ic-503 co2 board | The replacement part is smaller than the original and doesn't fit. | ||
| SONY |
CCDF45
|
Part no - ic503 co-2 board | The replacement part is smaller than the original, and doesn't fit. | ||
| SONY |
CCDTR5
|
Caution light comes on after a few seconds | Take-up reel stops after a few seconds and caution light comeson. | ||
| SONY |
EVCX10
|
Evf cable too short | Evf cable is too short. -to tokyo: when ordering the evf cable part number 1-556-824-61, thereplacement sent is about 4 inches (100mm) long. however, the originalpart is about 7 inches (about 165mm) long, and the replacement is tooshort. can you pleas | ||
| SONY |
CCDTR5
|
Part number for plastic shield | I need the part number for the clear plastic shield on thecassette compartment. -hq comments: the part number for this shield (called the cassettecover) is 3-736-834-01. | ||
| SONY |
KV27XBR60
|
Vertical bars behind picture after warm-up, replaced cm-1301 | During warm-up, three vertical bars would appear evenly spacedacross screen, each about two inches wide, first dim then progressivelydarker, tv or video in even with no signal power supply. using black rasterpower supply, found input to cm1301 ok, but outputs (y an | ||
| SONY |
SPP110
|
Id transfer between base and portable cannot be completed | Will not assign security code when handset is placed on base. | ||
| SONY |
XR7100
|
Balance and fade not working properly | Balance and fade not working properly. customer wired harnesson unit to install in car. | ||
| SONY |
KV32CX10
|
Horizontal lines top and bottom of picture, replace c-1548 | Two horizontal lines top and buttom of picture will fade some-what as set warms up. it will also be effected by adjusting the verticalsize control. | ||
| SONY |
CCDTR5
|
Drum reverses and unloads tape | When in rewind, drum reverses. when loading the drum slowsdown, then the tape is unloaded. the unit first came in with multipleproblems from an authorized servicer. the above problem occured when thevs-22 board was replaced. | ||
| SONY |
CDPC100
|
Disc jammed inside | Disc jammed when going into magazine after play. | ||
| SONY |
CCDF36
|
No zoom | Camera had no zoom functions. |