Sony Repair Tips
Search: sony
Results: 20073
Results: 20073
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| SONY |
CCDV8AFU
|
Part unable to fit | Replacement part will not fit - input cable too short.measures 2 1/2 inches should be about 4 inches (3p connector) stock fromkc. -hq comments: we are investigating and will advise. | ||
| SONY |
ITA650
|
Unit intermittently eats tapes, ogm and icm | A few units came in the service center with tape wound aroundthe flywheel, both ogm and/or icm. after removing tape, machine works ok.all machine torque seems ok. problem seems to be part number 117(chassis assembly, mechanical) where idler arm with ge | ||
| SONY |
SPP80
|
Phone does not ring | I have seen about 10 units with this resistor open. | ||
| SONY |
CCDF30
|
No capstan rotation | Unit had no capstan rotation pwm pulse wuld start to come fromic001 pin 6 then shut down. all voltages checked good around pwm drive. | ||
| SONY |
CCDV8AFU
|
No camera function | No camera function. we found no 5v from dc to dc converter.this measured 100Ω to ground. further tests leveled c-709 to measure100Ω. | ||
| SONY |
SPP100
|
Call waiting | A couple of customers have complained that while using theirspp-100, (call waiting) signals a second caller, they retrieve that callerbut then loose the original caller upon returning. this has been con-firmed by one ot our employees with call waiting. | ||
| SONY |
ITK300
|
Wrong value for r118 in manual | R118 is shown as 4.7k in manual, but is really 47k in theunit. -hq comments: thanks for the information. | ||
| SONY |
SL250
|
Not able to adjust tracking | Capstan speed problem. | ||
| SONY |
SLHF500
|
Tuner inoperative | Tuner working improperly with input select switch.tuner -no video (tuner)-blank screen no tuner numbers on display- blank (no display). ic301/16 tm52 bd. voltage 1.13v no sound.line/pcm -video on monitor and display showed channel 2. | ||
| SONY |
FD10A
|
New flyback transformer uses no silicore sealant | New replacement parts are different from original. -hq comments: thank you for your report. i contacted japan, and theyare checking the part compatibility. we anticipate the reply shortly. iwill inform you of the solution as soon as i receive it. pe | ||
| SONY |
ITA550
|
Unit intermittently eats tapes, ogm and icm | A few units came in the service center with tape wound aroundthe flywheel, both ogm and/or icm. after removing tape, machine works ok.all machine torque seems ok. problem seems to be part number 117(chassis assembly, mechanical) where idler arm with ge | ||
| SONY |
D10
|
High-pitched noise during play | There is high-pitched noise during play. the worm gear on thesled motor is turned back and forth intermittently, as the unit plays.the waveform at a negative pole of the sled motor is unstable. i have hada few units with this symptom. | ||
| SONY |
CDXR88
|
Unit was dead | Dead. when i shorted across ic514 everything worked for awhile (several minutes). progressively, the unit would lose its func-tions, go into mute and then give an irratic display. pin 1 ic514 wouldstart out, after being pulled high, at 5.2v then slowl | ||
| SONY |
WMF63
|
Failure of take-up spool | Numerous units eating tapes. one spool fails to take up.grinding noise is heard. play lever pops out of mounting rail - motorfails. takes about 1 hour to rebuild unit. -hq comments: thank you for your information. we have reported thisproblem to tok | ||
| SONY |
WMF73
|
Failure of take-up spool | Numerous units eating tapes. one spool fails to take up.grinding noise is heard. play lever pops out of mounting rail - motorfails. takes about 1 hour to rebuild unit. -hq comments: thank you for your information. we have reported thisproblem to tok | ||
| SONY |
SL5600
|
Very coarse picture in playback, self-recording worse | Playback of known good recording shows dc shift of video sig-nal every other horizontal line. ic001 and ic007 were replaced. foundic005 defective causing a switching signal to appear at ic001 pin 8, evenin playback. | ||
| SONY |
CCDV3
|
No picture in viewfinder | The unit had no picture in the viewfinder, all other functionsworked fine. | ||
| SONY |
CCDV1
|
Unit will not turn on | The unit would not power up. we found the dc-dc converter(dr201) inoperative. turn on and unreg. was present but there was nooutput. | ||
| SONY |
KXM120
|
Service manual missing part number, 1-536-941-11 | No part number for (video in) jack. part is not included aspart of (u) board or terminal block (page 8 of s/m, ref. no. 10 and 11). | ||
| SONY |
SLHF900
|
In audio e-e | No audio e-e, playback low audio and distorted. no -70vdc atpin 7 ic606 af-9 board. c008 hp-12 board short. |