Sony Repair Tips
Search: sony
Results: 20100
Results: 20100
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| SONY |
XK8D
|
System shuts down when power locks or horn activated in van | Units are new installs in a van. when the horn is blown orthe power locks are activated, the units shut down. have to re-power theunit. if you unplug the xk80 remote wires to the cdx-r88 unit, it willnot lock up when horn or power locks are activated. | ||
| SONY |
CDXR88
|
System shuts down when power locks or horn activated in van | Units are new installs in a van. when the horn is blown orthe power locks are activated, the units shut down. have to re-power theunit. if you unplug the xk80 remote wires to the cdx-r88 unit, it willnot lock up when horn or power locks are activated. | ||
| SONY |
CDXR88
|
Distorted right channel | Distortes right channel audio. it sounded hazy. | ||
| SONY |
XR7150
|
Squealing noise when tape changes direction | Technician at san jose ssc advised me of this problem. whentape direction changes, unit makes a squealing sound. he has not locatedthe problem, but has eliminated it by connecting a 10mfd electrolyticcapacitor from pin 4, cnp-909, to ground. this is t | ||
| SONY |
CDPC7ESD
|
Pgm play skips disk | After programming, order of playback everyother disk isskipped. | ||
| SONY |
KPR4110
|
Weaving picture, replaced ic-5007 (e board) | Picture had a slight weave that moved from bottom to top. allinput power supplys displayed except the on screen displays. | ||
| SONY |
CCDV3
|
Operation manual error/page 154/table 7-5 | On table 7-5, page 154 correct the columns headings to readfrom left to right: k00 (ic301 (13) ) k01 (ic301 (14) ) k02 (ic301(15). also change rew to ff and ff to rew. do not change the sw. ref.nos. - they are printed in the correct location. | ||
| SONY |
CCDV9
|
No characters generated in evf | Found no characters generated to evf but lcd display ok. | ||
| SONY |
D4
|
Will not track disc past second track | Unit would start mistracking on track no. 2 (3:00 on display). | ||
| SONY |
CCDM8U
|
Eats tapes | Unit ejects half way then stops. sometimes will eject buteats tapes. | ||
| SONY |
CDPC50
|
Table locating pin is broken | Table locating pin is broken. fix requires replacing4-924-445-01, however, time may be saved by using the following part4-912-652-01. | ||
| SONY |
AIR8
|
Power shuts down | Unit dead. | ||
| SONY |
CCDV3
|
Service manual error | For proper interpretation of which switch is fast forward orrewind, the arrow drawn above s353 should be reversed on page 117. -hq comments: we will publish a service bulletin on this. | ||
| SONY |
CCDV5
|
Service manual error/page 137/play switch | For proper interpretation of which switch is fast forward orrewind, the arrow above s353 (play switch) should be reversed on page 137. -hq comments: we will publish a service bulletin. | ||
| SONY |
AVU270
|
Unit would not retain memory | Unit would not maintain memory. schematic shows c503 on anodeside of d519 - not correct - c503 is on cathode of d519. found also an-other 10uf in parallel which was factory installed. both caps had de-creased in value. | ||
| SONY |
SLHF750
|
Service manual correction: rmt-143 exploded view | There is an error on page 241 of the service manual. | ||
| SONY |
EVS800
|
Service manual correction: rmt-424 exploded view | There is an error on page 313 of the service manual. | ||
| SONY |
KV2729R
|
Dark picture, open r-552 on a board | With the brightness and picture control to max. picture wasvery dark. this makes the second unit i have found with this problem. | ||
| SONY |
SLHF750
|
Unit dead | Unit was completely dead, i.e., no on/off function, no displayof any kind. tests revealed all dc voltages present and clock pulses werealso ok. clue to problem was pin 17, ic-1 on (fl-11) board. it neverwent low, but always had 3.5 vdc on it. obvious | ||
| SONY |
CCDV5
|
Drum motor does not start without help of battery | Drum motor does not start by itself on battery, but it workson ac. i replaced ic-509, 510 and 303 without avail. the only way tostart the drum on battery is by giving it a quick spin when it starts torock. -hq comments: one of the components on the bo |