Sony Repair Tips

Search: sony
Results: 20100

Make	Model	Symptom	Problem
SONY	HVL80D	Part availability for front housing	Underwater camera light turns on in transporting of unit.heat generated from light melts front housing. front housing part is notavailable (see s/b 22). the need for this part exists.
SONY	SL2410	Capstan speed and phase do not lock	In bii the picture has noise bars and the audio is unstable.tp11 on the (ss-13) board should have a 50% duty cycle. the waveform isdistorted with a series of negative pulses. the waveform at tp9 is ok.
SONY	EVC8U	Servo speeds up when pause is released	The capstan servo speeds up when pause is released thensettles to normal play.
SONY	PCM501	Static is head on audio out	Static or distortion is heard on the audio out.
SONY	CFSW501	10khz noise in high speed dubbing	A 10khz noise is heard only in high speed dubbing. all otherrecord, playback functions ok.
SONY	CPD1303	Flagging at top of screen when used with mac ii	After about one hour of operation, a flagging would start at top of screen when used with mac ii. this problem would not be seen with multiscan generator at macintosh ii frequency.
SONY	CPD1302	Flagging at top of screen when used with mac ii	After about one hour of operation, a flagging would start at top of screen when used with mac ii. this problem would not be seen with multiscan generator at macintosh ii frequency.
SONY	SPP150	Handset not receiving i.d. code	Handset not receiving i.d. code when placed on base unit.power led on base continues to flash, no communication between handset andbase. by hard-wiring from where i.d. transmission exits (mini-chargeterminals) to where i.d. code enters handset, proved i
SONY	SPP110	Handset not receiving i.d. code	Handset not receiving i.d. code when placed on base unit.power led on base continues to flash, no communication between handset andbase. by hard-wiring from where i.d. transmission exits (mini-chargeterminals) to where i.d. code enters handset, proved i
SONY	CDP350	Drawer closed but no focus search - then unit ejects disc	The drawer is closed but no focus search then the unit ejectsdisc.
SONY	STRAV1000	Switches do not work on front panel - remote ok	Power switch, tape mon. switch, eq defeat switch and othersnot working on front panel. remote is ok.
SONY	WMD6C	No playback	No playback. replaced dolby ic-101 and 201. still dead.found shorted c-138.
SONY	WMD6C	No record, right channel playback ok	No record, right channel playback was ok. waveform at bothhead leads showed virtually identical bias and audio waveforms. head waschanged. switched head wires. problem remained in same channel. finallykilled bias oscillator and looked at head input
SONY	STRVX550	No control of volume, bass, tremble and input switching	Volume was at one set level and would not change. displaywould change. also all inputs were being passed through the asp chip andswitching would not switch the asp chip. asp chip had been changed withno success. we had data circuit and strobe into ic
SONY	D15	(enter/remain) switch does not function	Enter/remain switch does not function. this problem has alsobeen verified in three other units with unrelated serial numbers.
SONY	KV20XBR	Set inoperable	Set was inoperable, i.e., no b+ from power supply. locatedshort in 200v line caused by c-703.
SONY	KPR41DS2	Shutdown, replaced green crt	Unit would go into shutdown when turned on. sleep light wouldcome on. found green picture tube shorting.
SONY	KV27HFR	Vertical instability and some horizontal flagging, c-520	Unit had vertical instability with either antenna or ext video(vcr playback). with an external video generator the unit was fine.reducing the gain of the generator unit would again have instability.checking the signal at ic-301 pin 47 and 48 found the s
SONY	STRAV450	Smelled hot, smoked	Customer complained that the unit smelled hot. r-666 hadoverdissipated and caused a hole in the circuit board. cause unknown.
SONY	KV27TX10	Squeal, install reactorless yoke, see sb tvp0114	Squeal sound.

Previous
1
...
804
805
806
807
808
809
810
811
812
...
1005
Next