Sony Repair Tips
Search: sony
Results: 20073
Results: 20073
Make | Model | Symptom | Problem | Solution | By |
---|---|---|---|---|---|
SONY |
SLHF1000
|
Need part number for pwr regulator holder (pg. 216) | Need mechanical piece that reference number 162 attaches to(pg. 216 of service manual). -hq comments: part number is 3-712-738-01, but is an unstocked part.tokyo is shipping some pieces, and i will send you one at that time. | ||
SONY |
SLHFR70
|
Shuts down | Unit will shut down in special effects and sometimes in play(intermittent). pinch roller will spill tape because the reel assemblywill not turn. i have come across 5 machines with this problem in thelast six months. the rotor becomes warped. | ||
SONY |
CCDV5
|
Intermittent shutdown | Intermittent shutdown and at times no start. found output ofsupply reel sensor varying in amplitude. cause - supply reel sensor wasnot fastened to chassis and was too close to reel - not allowing receivediode to sense proper light. varying amplitude w | ||
SONY |
KV2080R
|
Shutdown, open r507 | When the unit was first turned on, unit would shutdown. | ||
SONY |
WMF100
|
Grounding of radio connection board | Unit works only when cassette door is opened. shuts down whenclosed. radio connection board has trace worn and exposed causing it toground in the act of opening and closing cassette lid. | ||
SONY |
STRVX550
|
Relay chatter | Units power relay would chatter for some time and then wouldfunction properly. problem may not show again for a few days. | ||
SONY |
CCDV9
|
No auto focus | No auto focus. manual focus slow and hunts. | ||
SONY |
CDXR88
|
No tuner operation | No am or fm. (no scan stop. manual tune gives no backgroundstatic, or audio at all). found no output from q17 its base was 0.57vdc. | ||
SONY |
CCDM8SP
|
Vf jack part number | No p/n listed in manual. -hq comments: p/n is 1-562-183-00. | ||
SONY |
KV2092R
|
Bottom half of picture distorted, c1504 | Top half of pix was fine, bottom half was stretched and dis-torted. scopes of pin 3 or 6 of ic1501 shows rf riding on b+. foundc1504 had changed value - replaced problem cured. | ||
SONY |
FD42A
|
No pix, replaced q802, d802, ic601 and q602 | 1. no picture. 2. no high voltage. 3. bad keystone.1. weak drive signal on q801 base.2. open q802.3. no drive of pin 5 (ic601) open q602. | ||
SONY |
CDP701ES
|
High frequency whistle in one channel | High freq. whistle in one channel. found cold solder joint onlpf ground tab. this problem could occur on lpf401 effecting other side. | ||
SONY |
CDP203
|
Wrong part | The part number for the main board is incorrect. | ||
SONY |
SLHF1000
|
One weak or no video head output | Original problem was one video head tip broken. replaced withnew disk assy then had symptom of dirty or clogged video heads unable toclear, changed head disk assy. same results, (bis worked fine) changedentire drum assy. same results, changed head swi | ||
SONY |
KPR4110
|
No picture and no sound, resoldered the flyback | No picture and no sound. | ||
SONY |
SPP110
|
Id code is not sent to handset | Id code not sent to handset. test mode showed no problems.when handset was placed on base unit, id code would not be sent to handset. | ||
SONY |
ITK300
|
Time indicator not working, only color marker | Only color marks on indicator tube are illuminated. checkingvoltages, found pin 14 of ic401 to be 13v. checked resistance across d401and reading was zeroΩ. further resistance checks found c401 shorted. | ||
SONY |
MPKM8
|
Part number for mic cable | The elusive mic cable p/n is now known, and are on order fromjapan. -hq comments: this p/n was given to us last year, but was unavailable atthat time. we have confirmed with tokyo that this part is now available.ten pieces will be sent to our departmen | ||
SONY |
SLHF300
|
No tuner, no channel display | All functions ok, except for the tuner being inoperative andno channel display. unit stuck in line mode. | ||
SONY |
CCDV5
|
Viewfinder crt | The original viewfinder is using a crt made by nec with gener-ic number on tube c1m40p45. the replacement tube part no. 1-546-061-11 aslisted in service manual is made by matsushita gen. no. m01jpg5wb (seeillustration): the tube in fig. 1 uses board no |