Sony Repair Tips
Search: sony
Results: 20100
Results: 20100
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| SONY |
PSLX355
|
Schematic error | On pages 6 and 7 power and ground are indicated reverse towhat they should be on power input connector. hq comments: thank you for your information. we informed tokyo of thisproblem, however, the service manual was correct. | ||
| SONY |
CDP255
|
Improper chucking arm supplied | When replacing chucking arm on cdp-255, the part listed in thes/m is different than original part. specifically the magnet assy wasnot matched to the spindle so the chucking arm would not properly clampthe disc. | ||
| SONY |
ITA650
|
Speakerphone problem | Outgoing audio loud and quiet, only when speakerphone is used. | ||
| SONY |
CDP707ESD
|
No play (keep turning the disc) | 1) fop sled lock lever was out of position and prevented fopfrom getting into inner position. 2) no part number for this lock lever. | ||
| SONY |
WMF46
|
Motor hum (electrical) | Above replacement motor produces a low level (hum) audiblein headphones. used all parts that came with motor - screws, cushions,etc. large amplitude pulse can be seen on scope on black lead wire ofmotor. hum goes away when (pause) is activated. -hq c | ||
| SONY |
VTX1100R
|
Display on monitor (kx) has a rippling effect | The vtx1100r tuner came in dead. the line fuse f201 (1.6a)was blown. the fuse was replaced and the unit worked. the picture on thekx-1901a monitor was good however, the display had a rippling effect. | ||
| SONY |
KV4000
|
Intermittent vhf tuning | The vhf high channels could not be selected intermittently.we found switch, s-901, to have developed a resistance of about 400Ω.this condition did not allow a complete (low) state in the band-selectflip-flop, causing set to skip to uhf from vhf low. | ||
| SONY |
D7
|
Part number missing | A part number is needed for the cloth tape used in portable cdplayers to hold down wires in place. -hq comments: the part number is 3-831-441-xx. | ||
| SONY |
D10
|
Part number missing | A part number is needed for the cloth tape used in portable cdplayers to hold down wires in place. -hq comments: the part number is 3-831-441-xx. | ||
| SONY |
KV2780R
|
Interference pattern, replace ic-651 regulator | During first 15 minutes of operation, set displayed an inter-ference pattern on the screen resembling thin horizontal lines about 1/4to 1/2 inch apart, accompanied by a high-pitched squeal. this patternwas more noticeable on a bright scene. by bringing | ||
| SONY |
XR66
|
Spurious auto-reverse with new syscon ic (ic801) | Unit would falsely auto-reverse toward the end of a tape. noproblem noted with rotation sensor outputs. original ic801 wastc9310n-050. new sub is tc9312n-040. | ||
| SONY |
EVS700U
|
Shut down at end of tape | Unit would shut down at end of tape. would not rewind. nofunctions except eject. acted as if end sensor was bad. replaced, butsame problem. dc voltages were correct at sensors and q104 and q103 on(md-8) board. | ||
| SONY |
CCDV5
|
Part number for .25a fuse type ssfr (dead set) | Fuse not listed - need part number. -hq comments: the correct part number is 1-532-770-21. | ||
| SONY |
ACV55
|
No parts list in service manual | Need part number for the cable which corrects from the battery to the dc out. -hq comments: the part number for the dc out connector cord is 1-559-354-21. a parts list will be issued shortly. | ||
| SONY |
CCDV1
|
No video in record | Would not record video. no video output from (vc-12) board.found iris ring defective. | ||
| SONY |
ALL AUD
|
Remote for strav950 - d10 - kv25xbr | Do we have a single remote that will operate the above threeunits? -hq comments: the remote that will operate the above three units is thermu-70ii. a remote control receiver unit (p/n 1-463-815-11) is necessaryto make the d10 remote controllable. | ||
| SONY |
KV2780R
|
Pix distorted, replace fbt 1-439-372-11 | Picture distorted. | ||
| SONY |
STRAV880
|
Tv reception loss on cable system with strav880 installed | When the receiver and tv set are hooked to the cable system,the tv sets picture would snow-out. when the receiver was removed, thetv would look and work normally. | ||
| SONY |
SLHF300
|
Video/audio blank with pre-recorded tape | Video blanks out. found these symptoms:1. playback video/audio cut out (muted) with self-recorded tape or testtape.2. self-recording from this unit - playback good on shop sl-hf600.3. vd ctl and ctl pulses good. | ||
| SONY |
CCDV5
|
No camera record | Record switch inoperative. |