Sony Repair Tips
Search: sony
Results: 20100
Results: 20100
Make | Model | Symptom | Problem | Solution | By |
---|---|---|---|---|---|
SONY |
KV2650RX
|
Missing part number, cp003 1-417-087-00 | Part number is missing from service manual. | ||
SONY |
KV2649RX
|
Missing part number, cp003 1-417-087-00 | Part number is missing from service manual. | ||
SONY |
KV1953R
|
Missing part number, cp003 1-417-087-00 | Part number is missing from service manual. | ||
SONY |
KV1948R
|
Missing part number, cp003 1-417-087-00 | Part number is missing from service manual. | ||
SONY |
KV1222
|
Missing part number | Part number is missing from service manual. | ||
SONY |
XR530
|
No audio output - amplifier ic fails | Intermittent failure of output ic after several minutes ofoperation. low frequency oscillation with volume turned up, not obviousat lower levels. | ||
SONY |
KPR4110
|
B+ fluctuates between 135v and 50v, replaced ic-8 | The b+ line keeps fluctuating from 135v to 50v continuously.found 18v line fuse f3 on (e) board open caused by a shorted audio outic8. also pertains to serial number 7003297. | ||
SONY |
KV2680R
|
S/m drawing error on bridge rec s3wb60z, see s/b tvp007 | The basing diagram for the bridge rectifier is wrong in themanual. this error exists in all other listings for this s3wb60z(8-719-503-06) bridge rectifier. | ||
SONY |
PVM2530
|
Set trips ground circuit breaker | When plugged in, a ground fault interrupt breaker set is instandby. it will only turn on by remote. when it turns on, breaker pops. -hq comments: if capacitors c604, c612 are leaky, it will trip circuitbreaker in ground line. it may not show problem | ||
SONY |
KV2080R
|
Convergence, replace q706 on "c" board | Unable to converge (red). looking at a cross hatch, red wouldnot converge, also looked little out of focus. blue and green were ok.servicer had already replaced picture tube. changed h-stat, did not help.changed (red) driver transistor, resolved probl | ||
SONY |
FD270
|
Battery cover part number | The manual does not show a part number for the battery cover. | ||
SONY |
KV2783R
|
Part number missing, pincushion q-553 | Manual does not show a part number for the pincushion outputtransistor. schematic calls for a 23d1134, in the set is a 2sd1406. | ||
SONY |
SLHF900
|
Chassis sub assembly | A-4910-049-a (reel motor) board does not line up for mountingon chassis sub assembly, part number x-3691-643-3. holes are off. threeparts tried, none would fit according to technician. i tried and alsofound none would fit. -hq comments: refer to serv | ||
SONY |
D3
|
Battery will not take charge | Battery will not charge and hold charge. | ||
SONY |
SL300
|
Will not load | Will not load tape. | ||
SONY |
SLHF900
|
No display | Unit had no display. | ||
SONY |
CDP110
|
Makes noise and door will not stay closed | Unit makes noise and door will not stay closed. | ||
SONY |
CCDV1
|
Flashes | Video flashes. | ||
SONY |
KV2775R
|
Picture shifted, replace if block 1-464-597-11 | When tv was first turned on, picture was good. after five minutes, the picture has shifted. | ||
SONY |
KV25XBR
|
Video blanked out | By doing a voltage analysis on the d board, i was able totrace to q1504 - e2.4, b.4, c.12.9, q1506, e2.4, c.2.4, b.2.4 checkedtransistors they were ok. checked surrounding components r1537 changedvalue. |