Sony Repair Tips
Search: sony
Results: 20073
Results: 20073
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| SONY |
CDP510
|
Skipping on first track | Stock unit. skipping on first track. found sled drive vol-tage going to 1.8v-2.0v before the sled would move. loosened sled motorholding screw and repositioned worm gear to open meshing with sled gear.now drive voltage goes to 0.6v and sled moves smoo | ||
| SONY |
CCDV110
|
Multiple image in viewfinder and poor sound | Multiple image in viewfinder and poor sound. | ||
| SONY |
CCDV110
|
Unit would not power-up | Would not power up. | ||
| SONY |
CDP510
|
Disc will not clamp after loading | Breakage of chuck arm and loss of chuck arm roller. | ||
| SONY |
TCR302
|
No recording from one channel | No record one channel. found record level control rv301 open. | ||
| SONY |
TCW530
|
Record level will not set from tape | Record level will not set from tape, everything else ok. | ||
| SONY |
XR27R
|
Right side dead | Right side dead. | ||
| SONY |
CDP55
|
Unit skips | Transformer buzzing and unit skips. | ||
| SONY |
CPD1302
|
Dead | The +15v, +24v and +80v are loaded down from the d3 connectoron the d board. only voltage present is the vcc voltage. the 24 voltprotector d5001 is leaky. | ||
| SONY |
SLHF900
|
Am interference (1340 khz) | A customer lives about 1/2 mile from am radio station broad-casting at 1340 khz. the unit is displaying diagonal color lines whenplaying back an off-air recorded signal. -hq comments: i am sending you an ac noise filter and a video headshield cover. p | ||
| SONY |
SL5000
|
Tantalum capacitor failure | Upon installation of tantalum capacitor kit as per s/b #276c54 becomes leaky after about one week. this is the third such unit inabout one month that has done this. | ||
| SONY |
XR33
|
Unable to preset memory | #1, #2, #3 & #5 presets inop. #4 works normally. #6 willpreset a station, but displays its position as #2. i noticed i had topress hard on the keys to get a response. | ||
| SONY |
STRAV340
|
Bad capacitor - c303 | Main power switch would work but system power switch didnothing. manually resetting up ic301 would power unit up. furthertroubleshooting found an open capacitor on the reset line. | ||
| SONY |
KV25DXR
|
Intermittent loss of sound and video | Intermittent loss of sound and video. the bracket that theb board is mounted on has a small section which contacts the transistor,q2030. the emitter and base lead are shorted together causing thisproblem. | ||
| SONY |
CDP70
|
Intermittent skipping | I found that it would require a higher dc voltage to drivesled motor at or around the first track. | ||
| SONY |
SLHF900
|
Picture break-up during transition from line-in to tuner-in | Problem occurs when connecting two different power supplys, one tovideo input, the other to the rf input. during recording the input selectswitch is switched, between video and tuner input. during pb, some unitsdisplay a loss of sync during transition betwee | ||
| SONY |
CCDV110
|
X303 replacement part | Need p/n for x303 on ss-64 board, 4mhz crystal. replacementpart physically too large. -hq comments: replacement part is physically different, but does fitin holes in pc board. checking stock for misorder or mixed stock. | ||
| SONY |
XR47R
|
Micro scan input disconnected | No preset memory, no time set. | ||
| SONY |
SPP100
|
No charge indication | Battery won't charge. charge led off. main pcb differentfrom service manual. part # of board was 1-620-939-11, photo on page 23of service manual shows 1-618-075-12. found r603, r602 were wountedaway from circuit pattern. | ||
| SONY |
PSX75
|
Intermittent lifter operation | Tonearm would go to correct drop-point, but lifter would notdrop. touching the tonearm would cause lifter to operate. |