Sony Repair Tips
Search: sony
Results: 20073
Results: 20073
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| SONY |
KV2084R
|
Remote control button failure | Excessive and repeated remote control failures due to remotecontrol sheet rubbers are open. the following buttons are usually open:picture/volume/channel. | ||
| SONY |
TCFX510R
|
Unit comes on in rec mode | When the unit is turned on it appears as if the record buttonhas been pushed and is waiting for the play button to be selected. also,the tape counter does not work nor will the rec/play timer function. | ||
| SONY |
TAAX360
|
Incorrect part number for ic-101 | Both ic | ||
| SONY |
CCDV8AFU
|
Four vert. lines in picture during e-e or camera recording | Four evenly spaced vertical lines appeared in pix during e-eor camera recording. also appears during self recorded playback. | ||
| SONY |
KV2644R
|
Retrace lines, replaced r749 | Retrace lines in pix. | ||
| SONY |
KV2645RS
|
Audio pop on channel change, adj t207 | Loud audio pop on channel change, power on, or power off.changed t207 on a board, this reduced pop somewhat, but did not eliminateit. adjusted t207 while changing channels to eliminate popping. | ||
| SONY |
RME100V
|
Picture dropouts on tape recorded on evs-700u from ccd-v8afu | Dropouts occur in lp recording mode. | ||
| SONY |
SLHF400
|
Snowy picture in betascan when warm (approx. 1 hr of use) | After running the unit for approx. 1 hr, when cue or reviewis used picture is extremely snowy. unit was very temperature sensitive. | ||
| SONY |
XR77
|
No loading | Cass will not load. this happens on models xr-50, xr-70.and xr-77. 385 deforms with use (years) to the point where loading isincomplete. 387 joint lever assy can latch 386 threading arm assy. removecass holder, then carefully bend upwards to restore 9 | ||
| SONY |
ESR10
|
Wrong part number | Reference numbers 229 and 230 are crossed. in orderingreverse pinch roller (item 230 on page 26 of service manual), i receivedforward pinch roller (item 229). -hq comments: we will issue a s/b. | ||
| SONY |
KPR4110
|
Cp6001 open, replaced cp6001 | This unit is used with a panasonic vcr pv-1770 and when thevcr comes out of the scan mode (review) the unit will go into hv shutdownand sometimes open cp-6001. this is caused by a problem with the vcrchanging the horizontal freq. this unit opened cp-60 | ||
| SONY |
SL5200
|
Int. blows f001 and q002 | Unit would very int. blow q002 and f001. it was very hard tolocate the problem because short would disappear on the 12v line before itcould be located. | ||
| SONY |
SLHFR90
|
Servo adjustments in manual incorrect | Test point for betascan drum speed adjustment (p. 202) isincorrect. also, x-0 jitter adjustment is impossible - can -hq comments: correct test point for betascan adjustment is ic021 pin 5.x-o jitter adjustment is not necessary due to servo improvement | ||
| SONY |
CDP70
|
Display indicates all zeros | Display would not function, all zeros displayed at alltimes. all other functions were ok. inspection revealed no clock pulseson pin 37, ic106. | ||
| SONY |
CDP203
|
Rf pll alignment correction | Service manual says to adjust l201 for 4.3218 mhz. i believethis to be in error and l201 should be adjusted for 4.2818 mhz. -hq comments: you are correct. i will issue a s/b. | ||
| SONY |
EVC8U
|
No video pb | 1) unit had no playback video - just intermittent flashes.2) poor sync and rainbow in picture. | ||
| SONY |
SL5200
|
Color beat during playback with audio in connected | Color beat on monitor only during p/b when audio input isconnected (e-e is ok). | ||
| SONY |
EVS700U
|
Video drop-outs after repeated playback | Customer complaint: after repeated playback of a section oftape, dropouts develop. 1/4 inch diagnal scratches found near center oftape. not sure if problem develops during cue/rev or pause. unable toduplicate scratch at ssc. | ||
| SONY |
CFS700
|
Wrong part # in s/m | Customer says part supplies does not match part in unit. seeletter from customer. -hq comments: the correct p/n for the spring is 4-854-771-00. a s/b wasissued - tape recorder #204. | ||
| SONY |
AIR8
|
Screw part # | Customer has ordered part twice, and insists that it does notfit. part # on part matches that in s/m. is it possible that there is atypo in s/m? have tried to verify but do not have this model in shop. -hq comments: steve, i checked with kcp. last s |