Search: sony
Results: 20073
Make Model Symptom Problem Solution By
SONY KV2670R
System control lock-up, replace x-101 ceramic osc Tv has hv with ear next to speaker. there is noise fromspeaker. but there is no brightness and using the power switch on frontof tv or remote hand unit the tv cannot be turned off, clock at pin 1ic103 less than half the amplitude given on the circuit d
SONY KV2670R
System control lock-up, perform procedure for no vip Tv has hv and with ear next to the speaker there is noisefrom the speaker. but there is no brightness and using the power switchon the front of tv or remote hand unit the tv can not be turned off.
SONY STJX205
Am tuning interval st-jx205/jx520 St-jx205 is in the 9khz am tuning mode. no procedure in thes/m for changing the am tuning mode to 10khz.
SONY BMC220
Right half part of picture is green On pb and e-e (with jig), right half of screen appears green.left half okay. disconnecting chroma on jig gives good b&w picture.found 8-pin socket for the saticon tube was damaged electrically. wig-gling socket caused problem to appear and disappear.
SONY KV2783R
(s) in sound, adj rv-830 on "x" board Customer complained about (s) in sound.
SONY CCDM8U
Tape transport jammed (no mechanical movement) Tape transport sec jammed unit totally inoperative. dis-assembled entire transport sec to find gear b damaged teeth sheared off.plastic gear meshed with metal gears. ls chassis had to be removed whenchassis was not in ready mode due to the damaged gear
SONY SL2710
No stop in pause No stop in pause. the capstan would contain to pull tape try-ing to get a clear picture in pause. the tape pulled would still on exitside because the reels do not take up tape in pause. these units hadmany hours on them and there were wear marks on up
SONY SLHF900
Int loss of rf from head amp This unit would int lose rf output from ic001 pin 27 and 16.ic001 would switch to the record mode of operation, because pin 13 was at4.5v. ic407 v-rec p output was int wrong.
SONY CCDV8
S/m correction (vi-6 board) S/m error. page 110 location f-15. junction point missingfrom node of c140, r140, r145 and r146. this node is in the main videosignal path and should be correctly marked. -hq comments: this node is the point where pb/ee video is divided into2 paths.
SONY HVR200
Missing part number (gear) I need part number for gear located by 57 on page 17. -hq comments: please refer to s/b #237 (feb 7, 1986). p/n requested isx-2394-407-1 (shaft 7 ass
SONY G2000
Part # for systems control cable We need part # for the systems control cable that connectsthe components of this system together. -hq comments: the part number is 1-557-891-11. we have a s/b on this,no. 211.
SONY KV2782R
Snowy pix, replace antenna sw q-112 On this model and models with related circuit the following symptoms may occur: snow, snowy pix, adjacent channel interference,interference from auxiliary terminal.
SONY KPR4110
A blue and green line 1/2" high, tape on mirror On the screen appered a blue and green line about a 1/2 high,extending from the upper right to the center of the screen.
SONY EVS700U
Intermittent noise during pcm playback After warm up excessive intermittent noise appear on tracks ofpcm playback. rv102 very sensitive. ic103 & d101 temperature dependent.
SONY CCDV8AFU
No self recorded playback This unit was not recording atf signal. it caused the unitnot to play back the tape, which was record in this unit. this unitplayed all other tapes fine.
SONY CCDV8
No color in record mode This unit played back with color but did not record color.
SONY KV2649RX
Plug set produces a pulsing sound through speakers, q604 Plug set in master power switch on set produces a pulsingsound through speakers. when power switch is pressed set comes on withnormal picture and a slight hum in audio.
SONY CFSW400
Missing part number No part number listed for front cabinet #10 on page 25 ofs/m. -hq comments: the part number for the front panel (ref. #10) isx-3327-907-1 silver and x-3327-908-1 black. a s/b has been issued.
SONY TCM10
Part number Item number 28 page 30 of s/m for tcm-10 lists the partnumber for the stopper washer as 9-910-999-34. this is a no longeravailable number. -hq comments: this washer should be p/n 3-315-384-11.
SONY SL20
Part number for black tuner preset lid Ordered a black preset lid for an sl-20 (p/n 3-684-177-01) butreceived a silver lid. tried ordering part number for other units withblack lids but experienced same problem. -hq comments: two known good numbers are x-3684-146-1 for a black lidwith red s