Sony Repair Tips
Search: sony
Results: 20100
Results: 20100
Make | Model | Symptom | Problem | Solution | By |
---|---|---|---|---|---|
SONY |
XR65
|
Open trace | Foil open on volume control board. this foil appears to haveburned open. | ||
SONY |
XR50
|
Solenoid drive transistor | Cass. will manually eject, but not automatically at end oftape play. | ||
SONY |
XR45
|
Voltage errors in manual | Many voltages in the power supply seem to be in error andneed clarification. voltage difference exists on the same foil conductor. -hq comments: a list is provided below of the key voltages: please makea note of these voltages in your xr-45 s/m also.q | ||
SONY |
WMF10
|
Motor noise | Servicer has had several complaints of motor noise throughhead phones. this problem does not show up on wm-10 but only on wm-f10. -hq comments: electrical motor noise occurs when the b+ line is furthertaxed by: 1) loaded motor 2) decayed battery 3) l | ||
SONY |
WMF1
|
Open rv-1 | When receiving stereo fm signals the sound was distorted.we found rv-1 to be open - vco adjust. | ||
SONY |
WM10
|
Loose spring | Small hair spring that sets in plastic groove of auto shutoff part of pinch roller comes out of groove and unit will not start toplay auto shut off taken over. | ||
SONY |
TCK555
|
Defective ic202 | Unit would go into rec mode, however reel tables would notturn and it would eat tapes. found that b+ (10v) to board was low.isolated problem to shorted ic202. | ||
SONY |
TCFX44
|
Defective ry301 | This unit would play back fine. however when recording therewere intermittent passages with motorboating. we found ry301 (whichswitches the head between pb and rec) to be defective. this caused a poorground connection on the head. | ||
SONY |
TAAX500
|
Fractured ground lug | With the volume control set at minimum there is an imbalancein the sound level and static in one or both channels. | ||
SONY |
STRVX550
|
Missing part number in manual | No part number for fm tuner in s/m. fm tuner number isa-434-402-9a. | ||
SONY |
STP75
|
Defective control upc - ic603 | This unit did not light any display segments and there wasno tuning. a check of - control upc - ic603 revealed that the ic wasinoperative. | ||
SONY |
RS30
|
Short on secondary of t901 | No power. spring connector was bent towards pc board,shorting to ground the secondary of t-901 (power trans). | ||
SONY |
PSLX500
|
Audible noise | Low level thump or rumble like noise is heard when everhorizontal drive motor moves tonearm. | ||
SONY |
PSF5
|
Instructions in manual | Page 17 of service manual, in order to perform verticalbalance and horizontal balance we recommend using a 70mg, a 245mg anda 315mg weight. servicer has asked if we have a p/n for these weights. -hq comments: use the following number of washers to get | ||
SONY |
PCMF1
|
Defective ic531 | Sound breaks up (muting) on e to e and on playback ofprerecorded tape. found vco drifting. found no dc change at output ofic531 pin 1 although input to pin 3 was changing. | ||
SONY |
MTL10B
|
Defective q511 | All functions inoperative. unit had been worked on by dealerand microprocessor had been changed (ic502). found that there were nokey scan pulses to pins 30/31/32 and ic502. | ||
SONY |
M205A
|
Defective panasonic cassettes | I have had several instances of erratic or non-operation ofm205a at the pittsburgh fsc counter. in all of these, the customer wasusing panasonic mc60 cassettes. replacement with sony mc60 cassettescured all problems to satisfaction of customer. | ||
SONY |
ICF2001
|
Defective ic201 | The am was very weak and only strong stations could bleedthrough. we found the problem to be caused by incorrect bandswitching.we found ic201 to be putting out the wrong commands. | ||
SONY |
ICF2001
|
Defective filters q32/q51 | The fm muted above 89.20mc. am worked fine we found the pwmnot being properly filtered out of pll-1. | ||
SONY |
CFS99
|
Substitute part was smaller | Substitute part was smaller. -hq comments: late production cfs-99s used a larger gear (an) identifiedby p/n 3-579-641-00. please make a note in your s/m. |