Sony Repair Tips
Search: sony
Results: 20100
Results: 20100
Make | Model | Symptom | Problem | Solution | By |
---|---|---|---|---|---|
SONY |
KV2650R
|
Aft drift, leaky q024 | When you tuned a station it appeared as if the aft wassearching before it locked in on the strongest portion of the signal.vc was changing slightly before it locked. | ||
SONY |
KV2649R
|
No sound, replace ic605 | No sound in left or right channels. | ||
SONY |
KV2648R
|
No bar display, replace shorted q4028 | No bar display in any function except if volume was atmid-range. picture control would increase or decrease length of bardisplay. with color, hue or brightness there was no bar display.pressing hue, bar was all green. checking input to counter reset, | ||
SONY |
KV2647R
|
White h lines on the picture, replace q001 | The picture had white horiz lines producing a venetian blindeffect. there was also a buzz of 7-8khz in the sound. we found that thevc line was not being properly filtered. found q001 (fet) in the activefilter to be defective. | ||
SONY |
KV2647R
|
Dark picture, shorted c725 | This unit had a dark picture and the picture control did verylittle. found c725 shorted. | ||
SONY |
KV2142R
|
No picture, replace c2213 | 33v line shows video on dc of about 1 1/2v. after warm-uptuner drifts off channel with or without afc. | ||
SONY |
KV1953R
|
No tuning operations, replace ic003 | Channel up or down inoperative. also unable to erase anychannels. no logic change at pins 1-4 on ic003. | ||
SONY |
KV1952RS
|
No function, replace x2001 | Unable to control volume picture or channel change. led wouldnot light. found osc crystal low in amplitude at ic2001. freezingcrystal would change amplitude from 20mv to 2v. | ||
SONY |
KV1946R
|
Dark picture, r715 open | Picture was dark. measured screen voltage. range was from105-185 vdc. found r715 reading in the megΩ. | ||
SONY |
KV1922
|
Picture distortion | Set had pincushion problem. traced problem to q514. signalat collector was distorted. | ||
SONY |
KV1915
|
Dark picture | Picture was very dark. no brightness and no 900v to crt. | ||
SONY |
KV1914
|
Tuning drift | Stations could be locked in, but then would drift off. pin 10of ic201, aft amp out was floating, and voltage was varying. | ||
SONY |
KV1747RX
|
Dark picture | Color information was present but there was no luminance atoutput of ic341. input signal was ok. | ||
SONY |
KV1713
|
Picture distortion | Short width - from 1/2 to 1 inch. problem starts as pinproblem. servicer then finds picture just a little short of width. mayhave been like that for some time. | ||
SONY |
KP5040
|
Mechanical misoperation, greased small gear shaft bearings | The door would open only halfway and the motor would shutoff. the door would not close more than 2 inches before shutting off.there was no grease on the small gear shaft bearing. | ||
SONY |
KP5020
|
Overscan green crt | Green tube was overscanned. traced problem to q5337.transistor was leaky from collector to emitter. | ||
SONY |
FD20A
|
Dead, repaired cracks on board | Set came in dead. no power, whether using batteries or acadaptor. | ||
SONY |
KX2501
|
White vertical bar on the picture, see circuit change below | White vertical bar about three inches in from the left side of the screen. it would go away when the pc boards were opened out to the service position. | ||
SONY |
KV2649R
|
Intermittent power on/off, replaced d021 | Intermittent power on/off. customer controls erratic.found d021 leaky on mt board. | ||
SONY |
KV2649R
|
Volume low, replaced t205 | At maximum volume setting, the volume was about 1/3 of normal. inspection of sound output signal at pin 14, ic201, revealed avery low level signal. |