Toshiba Repair Tips

Search: toshiba
Results: 5617

Make	Model	Symptom	Problem	Solution	By
TOSHIBA	2134 (C) SK11 T1	With sound, no image just a few spots on the screen	Diode (d 305)	Diode replacement d 305 (ba158)	Eletrônica Garcia paraíso do to
TOSHIBA	2977	TV turns on, but tsound is no image, if you set the screen to maximum you will have retrace lines	An idiot closed a short on the RGB signal line, burning the CI micro and opening r228, r230, and r229 smd.	Changing the upc ci and resistors mentioned, tech, ederson (varjota-ce)	Edfersom
SEMP TOSHIBA	DL3244 A W	Backlight on, no image	CD17 SMD shorted on display board. check the other capacitors nearby		Eletrônica Cecé. Brumadinho MG
SEMP TOSHIBA	TODA LINHA U17 U17	After switching on, image problems begin, colored waves, colored stripes, etc.	Electrolytic capacitor c528 next to the micro, and it took work to find out (put a 1uf/100v one)	Resolved	NILSON TVs
SEMP TOSHIBA	LE4056(C) F STI	The logo appears and the screen turns off, (not LEDs)	Resistor r742 1m	1m resistor r742 and just replace	Eletrônica Garcia paraíso do to
SEMP TOSHIBA	LE4058(C)F	Burning led.	High voltage/current.	Replace the LED bars and replace the value of the smd resistors r740 and r748 from 4r7 to 6r8	evando viana
SEMP TOSHIBA	LE3273A	The green standby turns on several times, but it turns back to red several times, and it only takes a lot of trying to turn it on.	Power supply board defect	Exhausted capacitors on the power supply board, c310 and 311 of 1000 by 25 volts	Galileu Rocha
SEMP TOSHIBA	U18, U17 U18 U17	Sound only goes up to 12 menu does not select function boxes	Enter service mode press the control sound once, release and press again and hold the two TV volume buttons together and hold for 5 seconds,	Save the service mode press s on the control once and release press the second time and hold and press the channel key going up and hold for 5 seconds the TV will turn off and restart and ready it is saved and configured.
TOSHIBA	2016NMS U18	TV turns on normally, but with a dark image and it appears to be the screen capacitor, but it is not	After changing almost everything, even the processor, I decided to test the fly back	Fly back replace is good again	Eletrônica Renascer
TCL TOSHIBA	40S4700FS	Burnt voltage regulators next to the LVDS cable plug on the main board, Q900, Q901.	Oscillations in the electrical power grid apparently.	Replace voltage regulators next to the LVDS cable plug on the main board, Q900, Q901.	Adriel SS
TCL TOSHIBA	40S4700FS	No image	Burnt voltage regulators next to the LVDS cable plug on the main board, Q900, Q901.	Replace voltage regulators next to the LVDS cable plug on the main board, Q900, Q901.	Adriel SS
TOSHIBA	2159OFS-U19	Closed vertical (white line in the center of the screen), but with sound	Ci responsible for the vertical (q301), oscilloscope board transistor (rgb) and resistor r442... getting very hot	Due to the short generated by the ci (q301), excessive heating occurs in the other components... replace it and problem solved! Note: case
SEMP TOSHIBA STI	DL3270(A)W	Does not turn on, LED does not light up	Does not provide 12v, 12v power supply with 2.6v	Transistor q305 2x smd with leakage, and the same transistor 1p	Center som
TOSHIBA	40L2400	Screen with some lines in the background	Defective tcon board	One resolved it with cleaning. Another resolved it by changing the tcon.	Elenilson lua nova
TOSHIBA	40RV700FDA	No audio and normal image	My case was resoldering on the power supply board	Solve all power supply plate	Eletronica do Almiro
SEMP TOSHIBA	55L5400	Tsound are times when it turns on and tsound are times when the logo just appears and goes back to standby	N805 3.3 volt regulator was only at 3 volts and tsound were times when it was normal	Barter it	Central Eletrônica
TOSHIBA	2082 U8	LED turns on and off	Horizontal output shorted	Replace horizontal output bu2508dx	FÁBIO
SEMP TOSHIBA	LC3255 A WDA	The image is flashing, the backlight is flashing, if you notice the problem it will be due to the low 12v voltage.	In my case it was the v806 next to the 12v connector on the main board, it is npn and was open, just compare it with the ones next to it, they are the same reference.		fabiusmax
TOSHIBA	32HL86 PRINCIPAL E PLACA DE REGULADOR	Turns on and off, image turns on and off, does not turn on, turns off, relay hits and turns off	Change all 50v/10uf capacitors on the main board and a cap. from the 4-screw plate wsound tsound are 50v/10uf regulators	Replace all capacitors 10v/470μF, 50v/22μF, 50v/47μF, 50v/1μF next output, replace them all because they will be exhausted!!	Maike Sorriso-MT
TOSHIBA	2134 CSL	Image closed on the sides	Capacitor c635 330uf/50v with low capacitance	Replace c635	MARCONES DE ARARIPINA-PE