Toshiba Repair Tips

Search: toshiba
Results: 5617

Make	Model	Symptom	Problem	Solution	By
TOSHIBA	MS 8080 MUS	Display off	Open 4k7 resistor r 962	To replace	Emerson lima
TOSHIBA	MC855MUS	I don't read CDs, but tsound are books and everything, just don't read them	Defective optical unit can be replaced for the soh-ad3 which works properly, the soh-aav and soh-aan also work. in place of the original which is asoh-ad5
TOSHIBA	MC855MUS	No mute sound	Cold salad or defect in q 901 or something along those lines killing the negative 12 v	Resolder the transistor and check if the short in the zener diode hz902 is a 12 v zener, also check the capacitor ce913 if tsound is tension if not beforehand also check the components up to the transformer.
TOSHIBA	2090	Low supply +b around 75v, all the components that cause this defect were analyzed and they were all good...	Q432, smd transistor in the center of the board.	Do not replace, take off the board. (tec, edfersom varjota-ce)	Edfesom
TOSHIBA	LC4245	It doesn't turn on, nor does the STBY LED light up.	Capacitors cb 904,905, photo-couplers. in the case photo of the 5v power supply,	Replace mentioned components. I replaced them all to avoid future problems.	arock
TOSHIBA	LC4W245	It doesn't turn on, nor does the STBY LED light up.	Capacitors cb 904,905, photo-couplers. in the case photo of the 5v power supply,	Replace mentioned components. I replaced them all to avoid future problems.	arock
TOSHIBA	TV2134 SK11	High power supply (200v) LED flashing intermittently	Q 604		Ricardo Silva
TOSHIBA	40RV700	Does not turn on, orange LED blinks	Broken track between bd851 and pc802s photocoupler		FATEC eletrônica
TOSHIBA	TV 2087 U18	TV with sound and without high voltage with unlit tube	Fuse f470 500ma 250v broken, c446 4.7/250v with leak, and c884 33/160v leak with leak. The components in question were replaced and the TV worked normally.		Val
TOSHIBA	32L2400	The image comes on, then it disappears and is full of stripes, it takes a while and it comes back and stays straight	When you release the flet that goes to the screen, the image turns back on and then everything restarts all over again, so the reason for the faulty screen is short, change it and run to dim dim		eletronica publison natal rgn
SEMP TOSHIBA	32L2300	USB overload message, and it does not accept any commands!	Remove the coil that powers the IC160 responsible for the USB port!		Rodrigo cofferi
TOSHIBA	42XV650DA	No image, backlight on and everything works	12v missing from tcon: defect on the power supply board.	Shorted capacitor ce913 "kills the 12v" on the power supply board.	NelsinhoPira
TOSHIBA	2134	No sound comes out	Transistor very close to the sound output	Just remove it	JuniorNbk
SEMP TOSHIBA	U14 U14	Takes time to turn on and light filament	C 419 47x50 proximo saida horizontal		AGILDO ANDRADE
TOSHIBA	32RV700	I'm sound	Q8110, d8110 4v3, c8110 100k and c8113 100k on the power supply board		Ademar
TOSHIBA	TV2958GFS	Turns on the logo appears and turns off	Cold solder on the transistor.	Transistor qb20.	Eletrônica ideal
SEMP TOSHIBA	DL3975I	TV just keeps blinking green LED	12v power supply pulsing	Replace the dp9 ba158 diode. Tsound's no point in testing, I put an sk4f1/10 in and it worked fine.	Alexandre Oliveira
SEMP TOSHIBA	DL4077I	TV just keeps blinking green LED	12v power supply pulsing	Replace the dp9 ba158 diode. Tsound's no point in testing, I put an sk4f1/10 in and it worked fine.	Alexandre Oliveira
SEMP TOSHIBA	14415N U18	Blinking led	C865 10 n shorted	Changing is running to dim dim	Francisco de Jesus Conceição l
TOSHIBA	40L2500	Bus LEDs flash but do not light up, new or used buses.	Faulty LED driver circuit or dim control.	Next to the oz9902, add a 10k parallel smd resistor on top of the capacitor (c718 smd), deactivating protection.	RNSPTEC