Toshiba Repair Tips

Search: toshiba
Results: 5617

Make	Model	Symptom	Problem	Solution	By
SEMP TOSHIBA	TV14 VARIOS	No channel 3 and av i.e. blocked channels (when I tried to put them on they didn't appear, they were blocked)	Enter the menu (normal) and select the option, block av/tv (something like that), go to password and press "s" on the control several times, until it unlocks.
SEMP TOSHIBA	2934 SK91	It doesn't turn on, just the relay hits	TV hits the relay, LED stays off	-trazesto q604 -trazesto q606 capacitor c311	glaydysom rio branco ac
SEMP TOSHIBA	32L2400 40L2400	Does not turn on, LED is off	No. 07	Vdw904 measuring short, but it's the ci nw907's fault	Adrian (Chapadão do Céu Goiás)
TOSHIBA	TV1415NM U18	The television arrived with the pwm of the power supply shorted and the primary completely detonated, after removing the defect in the primary, the television arrived with voltage in the secondary, but it made a noise in the power supply and the voltage fluctuated wildly, a detail that when the +b of the fly was turned off -back the voltage stabilized at 64 v at +b.	Deflector coil with horizontal bearing changed from 5Ω to 10Ω	Replace the deflector or replace the entire tube. (edfesom ;)	Edfesom
TOSHIBA	U17	It heats up horizontally until it burns out and the power supply dies, the LED goes out	Coil will reflect short	Changing the deflector	FRANCISCOFERREIRA
TOSHIBA	TV2085(F) U11	It takes time to turn on, when it turns on vertically closed at the top and without tuning the channel	C 889 470mf x 35v		NEW PEK ELETRÔNICA
TOSHIBA	2122(O)FS U19	Whitish image with distortion to the left of the screen	Capacitors c446 (4.7uf at 250v) and c310 (470uf at 35v), both changed.	Replace the aforementioned capacitors	Francisco
TOSHIBA	2122(O)FS U19	White lines running horizontally across the screen	Replace of capacitor 309 (100uf by 35v) of the vertical ci	Replace the aforementioned capacitor	Francisco
TOSHIBA	MS-7980	It turns on all the functions but tsound is no sound even in the headphones	Str-w6759	If you can't buy it, it can be solved by placing a 470k resistor between the strw pins on pins 03 and 04 and then	eletronica publisom rn natal rgn
TOSHIBA	40L2600	LED current reduction	Change 12k r314 put 33k		AMIGO DA ELETRONICA
SEMP TOSHIBA	DL3254	No image, backlight lit	Cd18 shorted	Just remove	Adrian (Chapadão do Céu Goiás)
TOSHIBA	2159 U18	LED blinking and won't turn on	C865 (10nf) changed	Swap c865 10nf	MARCONES DE ARARIPINA-PE
SEMP TOSHIBA	DL4844(A)F	Standby LED is on, but nothing works	N806 shorted, n804 changed	Replace the two and run for the hug	fabiusmax
TOSHIBA	2959ISF LEM9/FS7	TV does not generate oscillation and LED is off	Perform a test on the capacitor c819 and the r876 smd 220r that was altered	Replace capacitor c819 10μF 50v and r876 smd 220r and run to hug	fabricio lima
SEMP TOSHIBA	SL40L2400	Connects with normal image. a few minutes later the image becomes flickering (duplicated).	Possibly faulty LCD. This model has a separate t-con!	The solution is paleative and in my case it worked! eliminate some flat cable tracks in the ffc_r connector. using a small piece of tape (durex) measuring approximately 4mm. Note: you have to test which point on the flat cable the tape should be applied to.	EvandoViana
TOSHIBA	40L2400	Power supply does not work tsound is no voltage in the secondary	Shorted diode at power supply vdw904. replace with 1n4148 smd		Oscar rj
TOSHIBA	LC4243W	Does not turn on, 5v missing.	Replace c832, c842, c843, c866 (primario pci power supply)		electronicssupplyparts - Gramado/RS
TOSHIBA	3252L(A)	Locking the image	Change the power supply ci and change all the ceramic capacitors around the ci		MATHEUS
SEMP TOSHIBA	LE3256	TV with sound, backlight on but no image	Cd25 shorted. on tcon board	Replace with a 10μF 50v electrolytic. respecting polarity.	Alexandre Oliveira
TOSHIBA	LC4046FDA	Turns on the backlight and then turns it off leaving only the sound	A burned out lamp	Replace	PATRICK ELETRÔNICA