Toshiba Repair Tips

Search: toshiba
Results: 5617

Make	Model	Symptom	Problem	Solution	By
TV TOSHIBA	TV 2098LMS U-16	This TV has a dark screen, the image appears but very dark, the characters are almost black when measuring the voltages of the filament 5volts screen voltage 250volts RGB 187volts already check the RGB capacitor and the screen capacitor are ok	I turned on the TV without the screen capacitor and it worked normally.	Replaced the scrin 2n2/2k capacitor and solved it.	BF.COLATNO
SEMP TOSHIBA	TV2050MAV U17	When you turn on normal brightness, it soon becomes dark with a weak image.	Broken track between r227 and d302	Fix the fault	Elias2305
SEMP TOSHIBA	TV2050MAV U17	When you turn on normal brightness, it soon becomes dark with a weak image.	Broken trail between r227 and 302	Fix the fault	Elias2305
TV TOSHIBA	TV2076	The TV comes with the keyboard and control functions locked	Tip: change the eprom and the capacitors polarized to the eprom.	Resolved: memory replaced.	BF.COLATINO
TV SEMP TOSHIBA	2157 U17R	This TV arrived with bu2508dx horizontal output,	After checking the power supply and peripherals and not finding anything abnormal, I put another bu2508dx on. The TV works normally without any heating, but if I turn off the TV using the remote, a very thin whistle starts and in a few seconds the horizontal output catches fire to the point of burning.	Solved after placing transistor d2624 horizontally.thanks	BF.COLATINO
TV TOSHIBA	2066MU	Once again; tv toshiba2066mu. this time with weak video signal. well; I started by checking that the control processor was normal because the characters in the contrast function worked normally, increasing and decreasing the dashes content.	But the video signal remained the same, very weak	When measuring the voltage on pin 30 of IC 601 TA8718N I saw that it was wrong. Following the alignment of this pin (the trail), I found R210 open at 20K. I just replaced it and the video returned to normal and the contrast returned.	BF.COLATINO
TV SEMP TOSHIBA	TC 206		Solution :r 809 changed		BF.COLATINO
TV SEMP TOSHIBA	TV2009	Gray screen. it has sound but no characters appear.	It was the memory
TV SEMP TOSHIBA	20A8EAV U-8	When it turns on, it makes a high voltage "popping" noise and goes into standby mode	Solved, just put another flyback		BF.COLATINO
TOSHIBA	TV2157 MFS	Queima tsh em stand by	Replace the original tsh with 2sd2553		Scorpion
TOSHIBA	2959IFS LEM9	The electrical discharge doesn't work, the LED only flashes and turns off the +b 140v, then it drops until it reaches zero	They were replaced d431 d432 q840 optical coupler but it remains the same		jose tinto
TOSHIBA	TV2995	Turns off after minutes	Altered resistor r470 (0.47r)		BEIVIDAS SERVICE
SEMP TOSHIBA	TVC102CR	Manual tuning doesn't work - aft inoperative	C104 and c172 swap		Rubens
TOSHIBA	TV 2083 U11	White screen without image without s d	The computer was frozen, having 3v9 on pin 25 of the computer, without reset.	I put diode in4007 on pin 25 of the micro to/ground, went into service mode, and reset, mute, holding mute on the crt again menu on the panel, I got to the mode and just pressed on the crt +vol+ then it reset.	Eterno Videotron
TOSHIBA	TVC 207 CR	No osd or osd running away	12v zenner with leak or short d. 302 near flay		Master Eletronica
TOSHIBA	TV2122-OFS U-19	Doesn't start	Defective main switch	Replace	Eletroclaudio Aguas Belas PE
TOSHIBA	TV2089 U14	No audio in av	Jamp gj06 no pino 61 do micro	Put the jamp	francisco rs
TV TOSHIBA	TV 2050 MAV	Stand by just blinks.	TV doesn't turn on		Renato
TV TOSHIBA	2998-FMS LEM3-A	Lower sound in one of the speakers even with balance adjustments in the center	Possible parts c 671 and c 679 both 47mf by 25v change without measuring to schematic the output, remove r677	And 676 both 2r2 will not be missed	cunha753
TOSHIBA	TV2996S	No audio signal, perfect sound output	Cold solder on rf module		eletronica zener