Toshiba Repair Tips
Search: toshiba
Results: 5592
Results: 5592
Make | Model | Symptom | Problem | Solution | By |
---|---|---|---|---|---|
TOSHIBA |
TV2177A
|
N/f LED lights up then goes out slowly | C-884 from b+ sold out | luizandradina | |
SEMP TOSHIBA |
TV1484
|
Does not turn on LED stays on | C872 35v 33uf electrolytic capacitor | jefersonpierini | |
TOSHIBA |
TV 2987
LEM6 |
Vertically closed and then disconnected | STV 9302a output shorted and capacitor 100x 35 volts dry and resistor r 327 burned | I replaced the capacitor, resistor and put a 9302h output, it replaces the other one without seismic on this TV, ok guys | HELIOMAR |
TOSHIBA |
TV2093-JAV U14R
U14R |
Inoperative and the LED does not light up | Strw5753 burned, d876 changed, cap 864 changed and r876smd 220oms burned | 1st I replaced strw, cap864 and the 5.6 zener diode and then I did a thorough search on the smd as it still didn't work with the help of a magnifying glass I saw the 876smd resistor with a small hole I took it out, measured it, replaced it and it worked fine | center téc |
SEMP TOSHIBA |
TVC 102
|
Doesn't start | Transistor 2sa1320 (q813) power supply board shorted base emitter | Responsible for powering the IC responsible for the horizontal output | Fernando Siqueira |
DVD TOSHIBA |
SD 3020VK
* |
The message on the display without dialing. | I fixed the driver and it works normally, after 1 hour it started to stop reading. | Just replaced the driver and everything was ok. | wagner |
TOSHIBA |
TV2988LMS
LEM8 |
Red screen with horizontal lines.deactivating by cir. protective | I checked RGB voltages on the 901 collector. | I removed the tube socket and checked to see if it was blocked. between filament and pin r, where it was found to be short. I laid the TV with tube down, turned it on and tapped the bulb until it released residue that was shorting out between the filament and g grid. TV returned to FC. normally. I alerted the client if this was the case. If it came back, the tube would have to be replaced. | OLÍBIO - ELETRÔNICA ESTUDIER |
TOSHIBA |
20A76MU
U8 |
Dead | Blown fuse | anos luz | |
TOSHIBA |
TV2957 FFS
|
Distorted butterfly-shaped reduced frame | Broken wire inside vertical side deflector coil | Ok | jair felix cap poço pa |
TOSHIBA |
TV2157NFS
U18 |
Intermittent defect. Sometimes it turns on, after several hours and turns off, leaving the LED flashing | I suspected the photocoupler and circuits connected to it, since the voltage dropped at +b to 50 v and the voltage on d885 went to almost 3v, triggering cir. 5v reset. | As it is an intermittent defect, I noticed that it replaced in det. temperatures, sometimes by even moving it (bending the board), I even thought it was cracked, or some cold soldering, but the capacitor c865 that connects the tr. excitement. from the photocoupler to the ground there was a leak. This one took a while! | OLIBIO - ELETRONICA ESTUDIER |
TOSHIBA |
TVC-145
|
Vertical opening and closing unstable image | Transistor q 302 bf 422 direct swap | teceletrik | |
TOSHIBA |
TV2922IFS
LEM 9 |
Burning fuse | Q801=strw6554a shorted, r876= 220r value changed and d883=rl3a shorted. | Replace of components | NILTON-AVARÉ-SP |
TOSHIBA |
MS6542CD
|
Dead power supply ok. | Xc701 crystal replacement | Valid for all mods from ms6528 onwards | artemio |
TOSHIBA |
TV 1030M
U17 |
Vertical closing intermittent | Remove glue wrapped around q405 and q430 | ramiresrc | |
TOSHIBA |
TV2957FFS
|
Menu keeps appearing all the time | Move the keyboard cable away from the power supply and fix it somewhere. | fabiusmax | |
TOSHIBA |
TV2092
U16 |
Dark image screen with 150volts | Screen capacitor on the kinescope board | Replace without testing because in the test it measures as if it were good. | ANTONIO NOBREGA(PATOS PB) |
SEMP TOSHIBA |
LUMINA
|
Dark screen even with maximum brightness | Retire o c902 cinescopio | If I put another one I get the same problem | Edvaldo |
TOSHIBA |
1478FM
U11 |
White screen with no characters and no sound | Damaged br24co4 memory | Replace the memory | MARCOS ROBERTO |
TOSHIBA |
2998
LEM5 |
Lines at the top | Cold welding and c308 | Check the soldering and replace the capacitor c308 (100μF/50v) | donizete |
TOSHIBA |
TV20
U17 |
When it turns on, it comes with a blue screen and it's just a blue screen | Smd transistor located on the tube plate | And just delete it and the TV will be ok! | rafael pantoja ig-miri |